S

stevehow101

New Member

• Jan 1, 2007

• #1

Hi
i put on a new ballast resistor and it burnt and broke same as the old one,there are two wires on each terminal is this correct?.

 

Wesley Pegden

Well-Known Member

• Jan 2, 2007

• #2

Evening Steve,
My Hybrid was fitted with a ballast resistor the body of the resistor was ceramic but it had only two spade connectors. It was wired into the feed wire from the ignition to the coil, basically it was just one wire in and one wire out. It cut the voltage at the coil down to around 7.5v chap.

Regards WP.

 

ormus

New Member

• Jan 2, 2007

• #3

we used to use SH ones from a scrap mk2 tranny vans. nice HD ceramic ones.
just 2 terminals. can be mounted anywhere too.

 

Wesley Pegden

Well-Known Member

• Jan 2, 2007

• #4

ormus said:

we used to use SH ones from a scrap mk2 tranny vans. nice HD ceramic ones.
just 2 terminals. can be mounted anywhere too.

Click to expand...

I reckon we is talking very much the same article here, mine had a tab on the body of it with a small hole in it, screwed mine to me bulkhead panel.

Regards WP.

 

S

stevehow101

New Member

• Jan 2, 2007

• #5

thanks lads