hi all gents and ladies..
i'm fairly new to the game of landymecano. and a little confused..
my disco1:
300tdi 94, non abs, 24spline, bent front axle case (looks like might have been replaced from a scrapyard), only noticed it after i put new wheelbearings and a new cv joint in... doh.
new axle:
off a 300tdi disco, 24 spline, don't know age. but with abs...
as the swivels are 100% on the donor axle i want to keep them, but swivel bearings felt notchy (cv and seal removed).
also grease in the wheelbearings and swivelbearings is brown... water damage? --> replace bearings.
? So am i right in saying: i have to stick with abs swivel pins and bearing setup.. right?
? what to do with the sensor? take out or leave in?
!!but more important is: can i just swap my stubs and hubs (from non abs) over to the abs swivel housing??!! the new cv joint is for both the abs and non..
please enlighten me
all the best
DD
i'm fairly new to the game of landymecano. and a little confused..
my disco1:
300tdi 94, non abs, 24spline, bent front axle case (looks like might have been replaced from a scrapyard), only noticed it after i put new wheelbearings and a new cv joint in... doh.
new axle:
off a 300tdi disco, 24 spline, don't know age. but with abs...
as the swivels are 100% on the donor axle i want to keep them, but swivel bearings felt notchy (cv and seal removed).
also grease in the wheelbearings and swivelbearings is brown... water damage? --> replace bearings.
? So am i right in saying: i have to stick with abs swivel pins and bearing setup.. right?
? what to do with the sensor? take out or leave in?
!!but more important is: can i just swap my stubs and hubs (from non abs) over to the abs swivel housing??!! the new cv joint is for both the abs and non..
please enlighten me
all the best
DD
Last edited: