Andy-Defender
New Member
hi everyone,ive got myself a snatch ive been doing loads of work in it and under it,but ive just started working on her engine,my problem is she starts but is only running on the right bank ??? im guessing that she has probably been parked up for some time out in afgan.also the engine is painted green so i think im right in saying its a recon..
ive changed the plugs, leads, dizzy cap, rotor arm, fuel filter and coil but its still the same,
i also had the carbs off cleaned them out all looked ok fitted a new valley gasket when i put it all back together.
when shes running you can pull all the left bank leads off and theres no drop in revs but if you pull the right side off she will try and cut out untill you put them back on.
when you try and rev it it splutters real bad and wont rev upand after about a minute off running the revs drop and she cuts out but it will start up straight away and run for another minute and then revs drop and she cuts out again....
anyone got any ideas cus im starting to loose interest in her....
ive changed the plugs, leads, dizzy cap, rotor arm, fuel filter and coil but its still the same,
i also had the carbs off cleaned them out all looked ok fitted a new valley gasket when i put it all back together.
when shes running you can pull all the left bank leads off and theres no drop in revs but if you pull the right side off she will try and cut out untill you put them back on.
when you try and rev it it splutters real bad and wont rev upand after about a minute off running the revs drop and she cuts out but it will start up straight away and run for another minute and then revs drop and she cuts out again....
anyone got any ideas cus im starting to loose interest in her....