cheers palThey are very easy to fit . the special hook bolts go into holes on the inner side of sills that have a tape over them . You position them using the short slightly angled attatchment projecting bar , then when you look underneath you will see where the inner edge of the mounting bars press against chanl sections of underside Hope that makes sense Its about a ten minute job each side
ps they fit both 3 and 5 door models the u sections go against bottom edge of sill lip , the bolts go thru the washers with holed welded to those square tubes .
its is also for looks not just a stepWhy the feck do you need a step to get in a freelander
lined them up ok but can not work out the brackets that came with runnersSorry no took them off my 3 door
the taper of the step faces towards the front , and the thing prettywell lines itself up , get it uder vehicle and laydown and you will soon work out how it positions .
It helps protect against car doors opening and causing side damage
u mean it helps stop the doors falling off?? cheers now sortedThey look okay to me , the hooked end goes in to the holes in sills and the trhreaded rod hangs vertically down and you lift the steps up to them . They are held horizontal with the open side upwards to go in the holes and the part at rightangles to thread rod goes onto bottom edge of hole
