cambridgecockney

Active Member
My front wipers and washers stopped working rear wash wipe worked ok. I have just had fitted a new wiper stalk and still no front wipers. Guess i shouldnt have bought another land rover. 2010 Feelander td4 HSE(soon for sale).
 
The front wash does work just not the wipers. Anyone know if controlled by a bcu. Motor works if you put live to it but no permanent live feed, this is according to garage. He insists motor is ok when a live feed added. £181.98 for a new one from landrover which i dont mind if i need it.
 
I have plugged in my delphi diagnostic and shows 2 faults i cant clear, B10A2 Crash signal and 92ca unkown.
I have also used it to tell me what the wiper position switches are doing when using wiper stalk. All positions show switch off and as i go through wiper switch positions it say switch on. There is no movement of wipers yet the mechanic told me the wiper motor works if he adds live feed.
 
I have plugged in my delphi diagnostic and shows 2 faults i cant clear, B10A2 Crash signal and 92ca unkown.

The only diagnostic that I know to clear the dreaded CRASH status is JLR SDD, which takes about 5 minutes to run the clear routine.

If the Delphi is showing the wiper switch is working, then the issue is between the CJB software and wiper motor, so either an output FET (unlikely), or a wiring issue.
Presumably you've checked the wiper fuse (F22) and relay (R11) in the engine bay fuse box.
 
Last edited:

Similar threads