Sakara
Active Member
That will be LR tool no.1 then. Most useful tool in the box......
Cheers
Is this big enough
Is this big enough
Sakara
Active Member
Sakara
Active Member
Too late
Already bought them when I was at work, excited about it all and sod all to do but the internet.
Sounds like a good job
I agree, expectations are high. No pressureThis is how it starts, I feel a rebuild coming on
mick the builder
Well-Known Member
Dangerous little buggers.It didn't help when my cutting disc decided to die and throw itself all over me at speed
mick the builder
Well-Known Member
A bearing destroyerThis is what it looks like. Not sure it's going to do too much anyway.
[/URL][/IMG]
Well, we'll see. You tend to get drawn in. You say to yourself, "I've done that, so I might as well sort that out too". And if you do a good job of one part, you don't want to do a shoddy job of another part because that's going to let your previous work down.................and so you get drawn in..........probably
Judging by the workshop and tools available you like to do a decent job.Can't be spinning smoothly with that sort of precision engineering
Last edited:
My first thought was the disc out of date but it's well in date, hope you had all the gear on. Scary when it goes pop.It didn't help when my cutting disc decided to die and throw itself all over me at speed
mick the builder
Well-Known Member
Avoid all temptation to grind with these discs, any side pressure can make make them suddenly explode. Im not usually a goggle person, just tend to squint my eyes but with these discs, i would wear eye protection at the very least. Looking forward to the build.
Sakara
Active Member
Thanks Mick, it will be quite slow and not as good as some of those going on now but I think it will be OK at the end. As for the discs I always use a full face mask. Most things I am happy with but cutting with cutting discs scares the **** out of me to be honest and I seem to be doing a lot of it recently.
Unscrew the lights, push sockets through body panels, then down through inner wheel arches. Job done.Not done much this week but thought I would 'quickly' take out the floor and the seat box. Took all day!
Started looking at removing the electrics on the tub but decided it looked like too much hard work so will have a go tomorrow, possibly
Sakara
Active Member
Cheers. Yeah, it looked ok before the hammer.
Once I manage to get it outside and jetwashed I will go at it with a wire brush as well as give it another ****ting.
Been looking at chassis spares so it looks like I can replace the spring seats and weld the rest. Depends if I find owt else I suppose..
Once I manage to get it outside and jetwashed I will go at it with a wire brush as well as give it another ****ting.
Been looking at chassis spares so it looks like I can replace the spring seats and weld the rest. Depends if I find owt else I suppose..
Sounds like a good plan. Give the outriggers a good looking over. They are a common rot area, but are replaceable like the spring seats.Cheers. Yeah, it looked ok before the hammer.
Once I manage to get it outside and jetwashed I will go at it with a wire brush as well as give it another ****ting.
Been looking at chassis spares so it looks like I can replace the spring seats and weld the rest. Depends if I find owt else I suppose..
