J

jeffers

Member

• Jan 19, 2016

• #1

Hi,
I've got the air suspension inactive message and its stuck in normal height. I'm in Cwmbran South Wales. Is anyone reasonably local able to read what's wrong for me. Happy to contribute.

Thanks in advance

 

wil2813

Well-Known Member

• Jan 19, 2016

• #2

just start it up turn steering full lock left then full lock right then back to centre prob low battery

 

J

jeffers

Member

• Jan 19, 2016

• #3

Have already tried the lock to lock thing to no avail, but, thanks anyway

 

J

jeffers

Member

• Jan 19, 2016

• #4

Would this unit read and reset the eas fault?
http://www.scantool-direct.co.uk/ic...nd-rover-jaguar-and-range-rover-vehicles.html
Cheers

 

A

Andy_J

Active Member

• Jan 19, 2016

• #5

The website claims it will work. I have an IID tool from GAP diagnostics and that does cover EAS, but is more expensive.
May be worth a quick look under your RR to check height sensors are still connected up properly (both electrical connections and the bars to the suspension arms). Make sure your battery is fully charged, as a low battery can cause all sorts of error messages.
Check the air compressor under the spare wheel

 

J

jeffers

Member

• Jan 19, 2016

• #6

thanks Andy will have a look tomorrow - looks like it may be cold but at least it should be fine!

 

J

jeffers

Member

• Jan 24, 2016

• #7

There was nothing obvious so took it to my local garage to be tested. The fault diagnostics were something like compressor running but pressure not rising and comms link lost. The chap cleared the fault and everything worked as normal. Pressure rose to 11.5 bar in less than the required time and all ride heights were correct and stable after the compressor stopped. Have been using it for a couple of days now and there have been no further problems. Fingers crossed it is OK.