Well, that's wrong, when the aircon button is pressed the aircon is OFF.According to Nanocom guides, AC Request & Grant require the engine ECU to tell the HEVAC it's ok to engage the compressor !!
View attachment 274967
Pins 13 & 14:
View attachment 274968
i would try and recalibrate the flaps using the nano function. shd not be reading 232pc..."Wow", you have done your homework, great thank you. On my nanocom it says left side blower 0 % and the right side blower is 232%. What now ?.
the a/c request is active low, and grant too.
the HEVAC needs to see the request conditions fulfilled and grant low to engage the clutch (or relay to the clutch, depending on MY). i had problems with my ECM not providing the grant signal in response to the request, so i have earthed the grant line to simulate the low, and the HEVAC still cycles on/ off properly based on all its other feeds
He said it's the blower not the flaps, but even so it should not read 232%. It's likely to be the blower motor drive transistor failed.i would try and recalibrate the flaps using the nano function. shd not be reading 232pc...
Good pointHe said it's the blower not the flaps, but even so it should not read 232%. It's likely to be the blower motor drive transistor failed.