LincolnSteve

LincolnSteve

Well-Known Member
DSC06726.jpg
Hi. A quick question about this manky thing. I'm getting to the point where I need to refit it (I have cleaned it up but don't have a picture handy). Does it matter where the pipes connect? I know how they came off so can reconnect the same way but I could run the pipes neater if I change things. There aren't any valves in this thing so I can't see a problem. Could someone with actual knowledge confirm. Thanks. Steve.
 
That bolt goes to a bracket on the chassis.roughly under the master cylinder. Trial fit it to work out the best way round, I seem to recall it fits 2 ways. I'm assuming you have single circuit brakes otherwise you need a 3 way. The line from the master goes to the top, the front goes to off-side front, the bottom goes down then back across the crossmember to the near side front, the rear goes along the top of the chassis to a flexy to a T on the axle.
 
Thanks for that. Mine was a real mess. Pipes not clipped on properly, cable ties everywhere and the part of the chassis where the 4 way bolts to had rotted away completely. I'm making it up as I go with this.
 
You must log in or register to reply here.

Similar threads

D
ACE pipe.
Replies
14
Views
1K
sierrafery
sierrafery
F
Bulkhead Identification
Replies
4
Views
821
Wildefalcon
W
kermit_rr
L322 ZF8HP70 gearbox problem
2 3 4
Replies
64
Views
2K
Graculus
Graculus
Montyjohn
P38A A couple of queries about rebuild EAS valve block
Replies
9
Views
707
Grrrrrr
Grrrrrr
Mad McNiff
05 RR Sport Cooling and purpose of mystery connections.
Replies
3
Views
645
Graculus
Graculus