RangeRoverJoe

New Member

• Feb 14, 2013

• #1

Hello I have got a Range rover that was 3.9 auto. This week I have remover the gas guzzling V8 and replaced it with a Perkins 4.236 Diesel engine with a miller conversion it is coupled to a old 4 speed LT95 gearbox which has air operated diff lock on the transfer box... is there any way I can make it stay in 4WD permanently as I wont be going on the road with it.... and i don't have any pipe to do it... thanks

 

jamesmartin

Well-Known Member

• Feb 14, 2013

• #2

vacuum puts it in or out of lock just leave it in lock, its has a detent so doesnt need vac pipe to be connected once either selected

 

RangeRoverJoe

New Member

• Feb 14, 2013

• #3

ok Thank you

 

jamesmartin

Well-Known Member

• Feb 14, 2013

• #4

you can just use an airline to blow selector to required position if you dont want to fit vac switch

 

RangeRoverJoe

New Member

• Feb 14, 2013

• #5

jamesmartin said:

you can just use an airline to blow selector to required position if you dont want to fit vac switch

Click to expand...

ahh good idea will it need much preassure to do that?

 

jamesmartin

Well-Known Member

• Feb 14, 2013

• #6

no not much ,i see youve not got hi/lo lever attached ,top cover needs to come off to adjust lever once its fitted in car ,but it would need hanging down off mounts to do that unless youve cut tunnel out

 

zen

Well-Known Member

Events Planner

• Feb 14, 2013

• #7

but you do have vac source..same supply as brake servo..use that