Southdown snorkel arrived today, will fit it at some point over the break. Are there any recommended sealants to use for the joints and of course any further places to waterproof? Hoping to run my extended breathers into along it.

I don’t really intend on needing it, it’s mainly for piece of mind that if I one day end up deeper than expected then I have some help on my side.
 
I used mostly silicone sealer .. and Self amalgamating tape.
 
yeah, I used an equivalent to Tiger Seal on my first snorkel, but dodn't have any when i did this one, so used what i had in the shed .. :)
 
mine are just ran up the side of the snorkel and shoved into the air intake at the top ;) with a few cable ties making sure they stay in place
 
Same as @StuRox said .. ran up to the bulkhead, into a Manifold then single airline up the snorkel and into the top, again with cable ties .. ;)

I run breathers from both axles, both gearboxes and the timing cover, hence the manifold to tidy them up.
 
Same as above with a manifold on the bulkhead to get just one breather pipe to the snorkel :D
 
I’ve got a pair of 2-1’s on it at the moment, will swap it for a 4-1 and break out the cable ties, thanks!
 
You must log in or register to reply here.

Similar threads

L
SOLD - Land Rover Ninety (Defender 90) 300TDi Auto soft-top
Replies
9
Views
5K
mondifa
M
Spot1
Disco 2 Climate air intake
Replies
3
Views
688
Spot1
Spot1
Salisbury Nick
P38A Water proofing the air intake
Replies
11
Views
1K
Salisbury Nick
Salisbury Nick
Sunray-I40
Defender Air Intake, Power & Fuel Efficiency
Replies
3
Views
3K
bankz5152
bankz5152
LandyMan
Freelander 1 Raised air intake
Replies
11
Views
2K
Nodge68
Nodge68