jax13

jax13

New Member
just changed the oil - everythings tight enough, no leaks anywhere, clean oil and plenty of it.

when the engine gets hot then i stop and start idling the oil light will come on then go off again with the slightest increase in revs.

is it possible this is just crud on the sensor (i did leave it far too long to change the oil so what was in there was like slightly runny tar) or is it possibly indicating pressure issues (indicating a gasket somewhere has gone)


any help at all appreciated on this one guys....... hoping it isn't a head gasket thing! (there wasn't any sign of water in the oil when it was changed or since)


taa!
 
Unlikely to be head gasket. 90% of the time it is the switch. You either change the switch or pay to get the oil pressure checked.
 
really dont want to worry you, but this needs looking at. could be just the oil switch, but it does sound a bit more ominous. ie after the hot injun?
either get the pressure checked at a garage, or buy/borrow a proper oil pressure gauge and fit it.
 
No expert but it sounds like either an oil pump problem or worn main bearings. I had an old 73 capri which hav very low oil pressure on idle. I cured it with a can of slick 50! - NOT SUGGESTING YOU TRY THIS. Take the advice above!
 
just been on a longer run than my normal run to work and it was fine...... maybe it is just the switch but i'll check it out just to make sure. the engine doesn't seem (from the guage) to be running hot at all, it stays a fraction below halfway on the temp bar all the time.
 
300tdi's normally have high oil pressure due to the toroidal pump, much better than on the previous 4-cyl motors, so pump problems are unlikely.
I don't think it is the switch, though that is the cheapest option. More likely getting the crud out has increased the big-end clearances.
So change the switch ASAP, just to check. If no change, get the sump off and change the bearing shells BEFORE the engine seizes up. It may be too late already, you may have to get the crank ground if it is badly worn.
 
just curious guys..... when getting said switch what would it be listed under???

oil pressure switch?


taa!
 
hi, im having the same problem with my 94 300tdi disco, may have nothing to do with it buut my coolant seems to be disappearing slowly aswell! am a little worried now after reading this thread! just changed 2 conrods coz they bent and did head gasket at the same time. drives fine tho
 
Hi guys,
I had exactly the same problem on my 300tdi, (158K on th clock) - Fitted a nw oil pressure sensor £4.95, took 5 mins to do and no more flickering oil light - EASY!
 
Hi All,

I know this is an old post, but was was the issue in the end? I have just started to get the exact same thing. Its my first Landy and want to look after it.

Appreciate you help!
Cheers
Ryan
 
You must log in or register to reply here.

Similar threads

Padda.116
300tdi disco 1, new head gasket oil leak!!
Replies
10
Views
575
Padda.116
Padda.116
D
D2 td5 Oil Light?
Replies
5
Views
655
tilly2
T
KiwiTDI
Disco 1 Torque converter lock up clutch “slipping” after lock up
Replies
3
Views
200
KiwiTDI
KiwiTDI
M
Drove through 2 feet of water, next day, clunking/sputtering when turning left/right slowly?
2 3
Replies
45
Views
2K
Stanleysteamer
Stanleysteamer
NeoX
Discovery 5 DTC on camshaft sensor - timing chain replacement?
2
Replies
26
Views
2K
Hippo
Hippo