M

Markdisco94

New Member
How long should it take for a Disco 3.9 V8 to get up to operating temperature? And where would this be on the gauge?

I can drive for 20 minutes and it won't be at the 1/4 mark on the temp gauge.

It only really gets near the middle on a motorway run.

I'm wondering if my stat is stuck open?

My previous experience of the RV8 you couldn't keep it cool enough!
 
That's it 1/4-1/3mark just on the bottom of the temp symbol, takes 5 mins at idle to do that this morning with frost everywhere or 1 mile down the road and stops there even on a hot day at + 25dec C, always been the same from day one, even with a/c on that's when the engine bay does get hot.
 

Attachments

  • SAM_2593.JPG
    SAM_2593.JPG
    178.3 KB · Views: 197
Last edited:
It's within the 'normal' range on the gauge in the picture. It could be that there is a slightly cooler stat fitted than standard but I wouldn't be worried if mine consistently ran like that. Worth changing the stat if the fuel consumption is not where you think it should be.
 
Change the stat. You need an 88 degree one for a 3.9 hotwire. Only a few quid and a bit of instant gasket
 
I have a different gauge to that. I'll take a pic after a bit of driving later. It is graduated like the fuel gauge but rotated 90 degress.

It's the fuel consumption that seem a bit low, even for this.

Am I right in thinking the ECU ignores the lambda sensors until the engine is at 70 degrees? If so, and my stat is wrong or stuck open, that could possibly explain it.
 
Markdisco94 said:
I have a different gauge to that. I'll take a pic after a bit of driving later. It is graduated like the fuel gauge but rotated 90 degress.

It's the fuel consumption that seem a bit low, even for this.

Am I right in thinking the ECU ignores the lambda sensors until the engine is at 70 degrees? If so, and my stat is wrong or stuck open, that could possibly explain it.
Click to expand...

Your temp gauge signal is not read by the ECU. The efi loom has a separate water temp sensor.
 
You can check when the thermostat opens by feeling the top rad hose. It will stay cold till it opens
 
Stat yes, sender looks right (single male spade): but tbh never needed to unscrew one. Your local Indy should be able to get these next day. Same goes for auto parts on the thermostat
 
Piccy time,

Here is what I see after 5 minutes idling and around 15 mins of driving:

10857993_10152918758588970_6365312298201244396_n.jpg


(I really need to clean the interior!)
 
You must log in or register to reply here.

Similar threads

R
Discovery 3.9 v8 - rebuilds, reliability, options….
3 4 5
Replies
92
Views
6K
resto_d1
R
Bustrucket
Disco 2 Td5 Overheating
Replies
3
Views
634
johnlad
johnlad
andyfreelandy
Freelander 1 Temp gauge on H and fans running with ignition on. Flat spot when pulling away. ( Solved)
Replies
11
Views
1K
andyfreelandy
andyfreelandy
farriermatt
Water problems 300tdi in a 1985 110
Replies
10
Views
612
farriermatt
farriermatt
cappers
Temp gauge reads hot when lights switched on....?
Replies
7
Views
1K
Rougharse Racing
Rougharse Racing