Hi are you still looking for fuel gauge? I came across one at Newbury 4x4 (sold as a 12V) but its a 24 Volt.

Rich
 
Ive got a fuel gauge and temp gauge - Both 24V. If you PM me i'll send a few photos. I paid £70 for both (same to you) or £35.

Rich
 
WP out of curiosity was your original fuel gauge missing, broken or was it reading full when the tank was only half full but correctly reading empty when the tank was empty? I had this problem & eventually found the cause.
 
It was physically broken, as in one of the studs had snapped - wasn't me!
In my experience, when they play up, it's usually the earth.
 
Ah fair enough. Yes you are right a poor gauge earth could cause a high reading, but I have found that the gauge second winding has increased its resistance.Cured with a Blanchard gauge & rather cheaper than ebay prices.
 
Used from Blanchard, or new?
I've bought a fair bit from Blanchard.
That higher resistance will be corrosion, no?
 
New & it was the same make as originally fitted.
I thought it was going to be corrosion or Afghan dust inside between the internal earth connection to the case, which is held tight by the insulated pillar for terminal 1. It was a bit tedious to dismantle, but it seems that the resistor has gone a bit high to the winding that exerts a permanent force to pull the need towards Empty, was lacking power allowing the winding that draws the needle to Full to gain dominance.
 
Are they really worth trying to repair?
They're at the annoying price point where it's worth a go, but rarely successful, in my experience.
 
Not worth it, but I like finding out how things work (or don't). Tedious to get inside by drilling out the three locking indentations then progressively prising away the bezel. Even if I replaced the offending resistor, I would never fully trust it again, the mangled bezel would look grotty and besides I have a new one that works fine. But without buying it I wouldn't have twigged how these dual winding gauges work, every indication from circuit diagrams suggest it is simply a single winding gauge.
I was wrong in my original description there is one resistor that feeds both coils. The second resistor is in parallel with Full winding to dampen the pull sensitivity. This is an E96 Series of resistor ie has 6 colour bands & initially I had read the value in the wrong direction! It is 1% tolerance & 50 ppm temp coefficient.
 
That's not a language that I speak, but I can repair electrical items and have successfully stripped and rebuilt starter motors, magnetos and generators, but I know nothing about electronic systems.
 
Further investigation reveals that both resistors are within tolerance. Even so, if the 220 ohm resistor was off tolerance it would not have been critical as it supplies both windings. The purpose of the two windings is that it makes the gauge read independent of voltage variations. The culprit appears to be a tiny amount of corrosion on the inside of the metal case that should press against the earth strip on the coil frame. The internal desiccator seems not to have done its job properly. I intend to clean this up & see if it works, so you may well have been able to sort it : )
 

Similar threads