defender1990

defender1990

Active Member
ive currently got a 1987 200tdi defender which i am bored with diesel and fancy a venture into petrol. I have been told that a 2.5 petrol should just bolt straight in using the 200 engine mounts and bellhousing. Can anyone tell me if this is correct or not?

muchly appreciated.

Peter
 
why an earth would you want to do that?
more guttsy
less power
not as good at wading of road

i could understand a v8:confused:
 
well i want a petrol to tinker with as ive tinkered with the diesel and on a 200 there is only so much you can do, i want to venture into carbs and petrol tuning and why not have the ease of both? keep the 200 for when i get bored of the low mpg
 
defender1990 said:
well i want a petrol to tinker with as ive tinkered with the diesel and on a 200 there is only so much you can do, i want to venture into carbs and petrol tuning and why not have the ease of both? keep the 200 for when i get bored of the low mpg
Click to expand...

you haven't got very much imagination pal
 
defender1990 said:
well i want a petrol to tinker with as ive tinkered with the diesel and on a 200 there is only so much you can do, i want to venture into carbs and petrol tuning and why not have the ease of both? keep the 200 for when i get bored of the low mpg
Click to expand...

id fit a v8 then:D
 
defender1990 said:
well i want a petrol to tinker with as ive tinkered with the diesel and on a 200 there is only so much you can do, i want to venture into carbs and petrol tuning and why not have the ease of both? keep the 200 for when i get bored of the low mpg
Click to expand...


IF yu tune the petrol injun it'lll implode on ya. and even with a stage 1 full race tune done to it. ya still wun't get more than 65mph out of it. best thing to do with a landy petrol injun is weigh the fooker in for scrap value. :p :p
 
defender1990 said:
christ i dont even want to imagine the amount of wiring on that ! :eek:
Click to expand...

ave got a 5.5 HP Honda engine outta fooked genny you can have if you want something simple to fettle with - you might have to drill/tap a few more mounting points on the bellhousing to make it fit
 
Sean said:
ave got a 5.5 HP Honda engine outta fooked genny you can have if you want something simple to fettle with - you might have to drill/tap a few more mounting points on the bellhousing to make it fit
Click to expand...
:hysterically_laughi
 
You must log in or register to reply here.

Similar threads

M
1992 200tdi 90 2.5 Body Parts Catalogue
Replies
5
Views
377
Mepps
M
steveshone
p38 fuse box following conversion from petrol 4.6 to diesel 2.5
Replies
7
Views
1K
mystery
mystery
M
Engine swap, 2.5vm out and 200tdi in
Replies
15
Views
2K
300bhp/ton
300bhp/ton
jimllshiftit
Any advice for novice welder about to stitch new rear cross member to 90 chassis?
Replies
3
Views
654
tottot
tottot
DPG213
Series 1 109 Engine Conversion - 2.25p or 200DI
Replies
14
Views
3K
nickjaxe
N