Fitting a 200tdi in me landy it had no lift pump on it and was given a new one by a mate but no instructions on which pipes go on it and to where ,this is a first time attempt for me to change a engine so sorry if sound think lol
Yep agree with that! various ones about so make sure you get the pump with the fittings in the correct orientation, look where the pipes are and should be obvious
Check small plastic 6mm pipe to top of injector pump connected to turbo pipe work.
Could also be a dodgy lift pump, but when mine used to go weak it only really effected top end was okay rest of the time
Had small split in a pipe so changed that and bled filter again ,she now operates at full revs but on a test drive the turbo aint kicking in ,checked all pipes on that and checked them against another landrover (brothers) and all pipes on correct ,waste gate working ,stumped again
When you say waste gate working have you checked it is closing fully.
If you take the little C clip off rod should sit passed the closed waste gate.
Do a web search on setting it up might be covered by trailer fitter videos.
Yeah done that ,truck starts and runs perfect just no turbo kicking in ,checked everything else bar injector pump I'm guessing engine as been stood a bit
Yeah done that ,truck starts and runs perfect just no turbo kicking in ,checked everything else bar injector pump I'm guessing engine as been stood a bit
Has your brothers been tweaked and yours not and when compared its seems like theres an issue but theres not?
1/8 to 1/4 of a turn in on the max fuel screw can make a real difference.