1

109inches

Well-Known Member

• Nov 12, 2015

• #1

When i replaced my rear crossmember on the 90 it had a bracket sticking out the crossmember on the exhaust side with nothing more than a hole in it.

When I bought the Land Rover the rear crossmember had turned to dust and the rear silencer portion of the exhaust didn't exist. So has anyone got a picture of how the rear part of the exhaust joins to this flat piece of metal coming off the crossmember. A Google search has proved ineffective.

 

ER1C

Well-Known Member

• Nov 12, 2015

• #2

Was that not the mudflap bracket ?

 

1

109inches

Well-Known Member

• Nov 12, 2015

• #3

No it comes of 90 degrees pointing toward the back of the rear wheel with nothing but an oval hole in it. There isn't one on the drivers side of the crossmember

 

G

gse1986

Active Member

• Nov 12, 2015

• #4

Presuming it's a tdi and not a TD, i think it's ESR95 you're after

 

flat

Well-Known Member

• Nov 12, 2015

• #5

It's just a flat bit of metal and an exhaust hanger poking off of it - will take a photo in the next day or so

 

ER1C

Well-Known Member

• Nov 13, 2015

• #6

So to answer your question, if the above is the item ESR95 (nice one GSE1986), which I assume it is...

There is a normal bog standard exhaust rubber ; NTC5582

Which slips over the right side of this item and the other hole in the rubber slips over your exhaust bracket.

 

zeaphod

Well-Known Member

• Nov 13, 2015

• #7

The earlier ones have a different setup - plate with a hole at the chassis and a plate welded to the rear silencer. You then use the collection of nuts/bolts/rubbers to make up the mounting

 

zeaphod

Well-Known Member

• Nov 13, 2015

• #8

Depends what is on the exhaust - hook for hanger or hole for bolt?