J

Jaymacd2000

New Member

• May 5, 2020

• #1

I recently refurbished my rear wiper motor, which when opened was very badly rusted. After derusting and freeing up the metal cogs etc, fitting new nylon drive cog and radial seal bearing in operates fine.
After reassembly, only problem I have now is when I start the vehicle with the wiper stalk in the off position (for the rear wiper) the wiper immediately starts to sweep.
Anyone know what I've done wrong.??

 

gold rover

Well-Known Member

• May 5, 2020

• #2

Welcome to our little community.

 

brianp38dse

Well-Known Member

• May 6, 2020

• #3

Hello and welcome

 

Hippo

Lord Hippo

• May 8, 2020

• #4

Welcome to the forum

This section is for introductions only. For technical help you should post your questions in the vehicle specific sections listed below, where owners of those vehicles will offer advice.

Main forum index:
www.landyzone.co.uk/forum

Freelander 1 and 2:
https://www.landyzone.co.uk/forum/land-rover-freelander.9

Defender, 90, 110, 130 (tratters)
https://www.landyzone.co.uk/forum/defender-90-110-130.7

Series 1, 2, 3 (tratters)
https://www.landyzone.co.uk/forum/series-land-rovers.6

Discovery:
https://www.landyzone.co.uk/forum/land-rover-discovery.8

Range Rover:
https://www.landyzone.co.uk/forum/range-rover.10