StuartDowney

Member

• Jun 20, 2015

• #1

So I have a 2,25 petrol series 3 and last week it started overheating. I replaced the thermostat but no change, had rad recored again no change, new temperature sender, new pipes but none of this has solved the overheating, when I take out the thermostat the engine runs to cold below the Normal mark. However I tested the thermostat and tried another new one to try and correct the problem both thermostats opened in a pan before the water boiled, but this didn't solve it either.

I can't think of anything else it could be? Any ideas?

 

S

sharkojoints

Member

• Jun 20, 2015

• #2

So with no thermostat fitted at all, the engine temp runs too cold?

If that's the case, I would still suspect the thermostat. You're changing something and it's having an effect, therefore the thing you're changing has to be prime suspect, no?

Are you sure the thermostats are opening fully?

 

oxides

Well-Known Member

• Jun 20, 2015

• #3

What are the symptoms? Is it blowing out steam? is it losing power? or is it just reading hot? Running without the thermostat should still allow the engine to run at a reasonable temperature. Could the voltage regulator that feeds the temp gauge be nadgered? - if so your fuel gauge will be misreading as well.

 

StuartDowney

Member

• Jun 20, 2015

• #4

Thermostats are opening fully, where would I find or test the voltage reg? It just seems to be showing hot, when I open the rad cap there is steam. The bottom hose also seems empty and cold with the thermostat fitted and is warm with trickels of water when stat out

 

StuartDowney

Member

• Jun 20, 2015

• #5

And come to come of it the fuel gauge read above empty and I ran out of fuel yesterday

 

freelance

Well-Known Member

• Jun 20, 2015

• #6

Voltage reg, little box attached behind the dash

 

oxides

Well-Known Member

• Jun 20, 2015

• #7

It clips into a sprung bracket that's on the back of the speedo - don't confuse it with the flasher unit!

 

Blackburn

Well-Known Member

• Jun 20, 2015

• #8

Mine screws on the back of the speedometer.

 

oxides

Well-Known Member

• Jun 20, 2015

• #9

Blackburn said:

Mine screws on the back of the speedometer.

Click to expand...

Posh ******!

 

StuartDowney

Member

• Jun 20, 2015

• #10

So I've been driving the landy all of today with the thermostat out and it hasn't passed the Normal level, tried also bleeding the system at the heater hose and will try the stat in tomorrow and see how it goes