B

biggerbinns

Member

• Mar 6, 2009

• #1

Hi, Well the P38 stopped again and the BeCM I am told is to blame.
All ok after being reprogrammed again but I am going to have to invest in a new BeCM.
Can anyone assist me with a good place(s) to get one from and the right price to pay?
I would of thought by now their are some very clever folk out there who can re condition them for the fraction of a new price.
Any help appreciated before it dies again.

Cheers

Mike:doh:

 

Irishrover

Well-Known Member

• Mar 6, 2009

• #2

Send Mtech a pm if you are in the U.K. and me if you are in Ireland..........we may be able to help as we both have the gear to go where Test Book can't to identify BECM faults and access to most board level components if they are shot.:bounce:

 

B

biggerbinns

Member

• Mar 7, 2009

• #3

Ideal, I will look them up and make contact with M tech to see how they can help.
Cheers for your reply.

Mike

 

B

Beast o Bodmin

Banned

• Mar 7, 2009

• #4

take out the becm and fit manwell components.it will only go wrong again

 

K

Kev1000s

New Member

• Mar 8, 2009

• #5

message sent,i can sort you out...Cheers

 

tufty

New Member

• Mar 9, 2009

• #6

P38 Range rover Becm Repaired & Programmed at a fraction of the cost!-P38 Range Rover Electrical Common faults and Fixes

 

M

manandvan

New Member

• Mar 14, 2009

• #7

hey beast of bodmin, have you done this?? i,m in the process, need a little help, ive done most of it though. cheers