Have a look at post 93 , I posted a pdf of the 200tdi overhaul manual got all,the torque figs and how to do what you doing 😀
Sorry Mate I forgot you posted that I have downloaded the 200tdi one. Found the torque it is 130 to 136 nm, worried now that the bloody bolts may snap or stretch, as I will be doing it twice, once to plastigauge then again to finally fit.
 
I would do the torque in stages and if crank won’t turn at say 70Nm then got a problem, you can reuse the bolts if in good condition as they’re not designed to yield at that torque
 
Bit farther forward, bearings and crank fitted, Head back from machine shop pressure tested and skimmed, bores honed with new rings, timing case and pump back on. Just waiting on sealer for ladder frame and sump also head gasket kit.
Not sure which to do first though.
 

Attachments

  • 20250531_195528.jpg
    20250531_195528.jpg
    274.9 KB · Views: 12
  • 20250603_121429.jpg
    20250603_121429.jpg
    470.9 KB · Views: 14
  • 20250530_191143.jpg
    20250530_191143.jpg
    227.8 KB · Views: 12
Sealer has not come yet for sump so fitted head with new bolts, went by the book first torque 40nm then 2 60 degree turns, hope Ive done it right. Also fitted rocker arm and push rods etc. Can the timing belt be fitted now ? or do I need the flywheel on first ?
 

Attachments

  • 20250608_100442.jpg
    20250608_100442.jpg
    579.1 KB · Views: 15
  • 20250608_111437.jpg
    20250608_111437.jpg
    332.3 KB · Views: 15
I would remove the rocker shaft.
You now have some open valves.
Which could be an issue turning the engine to time it right.

J
 
Not sure what you mean, watched a couple of vids on youtube and copied what they done,
What Marjon means is with the rockers fitted and no cambelt, if/when you rotate the engine to line up the timing marks any open valves could make contact with the pistons.
So safest to remove rocker gear then fit belt etc.
This why when engine has a cambelt change during normal works you line up marks before removing the belt.

Ps do not believe all you see on youtube, joke in the mechs and other trades is the customer said it looked easy on youtube:p
 
That's how I did it on my rebuild and it runs great. Flywheel has a locating dowel so providing your crank is aligned properly the flywheel peg will fit.

I guess using the flywheel pin would be slightly more accurate than the mark, but the teeth on the belt limit how much fine tuning you could do anyway.
 

Similar threads