[stevebrookman]

Morning all,
Trying to change the pressure sensor (the green thing) attached to the driver unit in the air suspension box. Taken out the pump but cannot see the sensor-can see its two red wires running away somewhere. Any ideas how to get to it?
Regrds

Steve

 

[dogsbody]

It's not on the driver unit, it's on the valve block. Valve block out to get at it.

 

[stevebrookman]

Cheers!
Valve block looks a bit fiddly to get out-do I havt to disconnect all the air pipes?

REegrds
Steve

 

[stevebrookman]

Found it under the valve block.
Will leave it for now and see how it goes next week whilst towing the tin tent.
Has only faulted once since last August and that was on a long trip.
It was
"pressure signal constantly high".Took most of the connectors apart in the EAS tray and sprayed contacts with contact cleaner.
If fault happens whilst towing will pull over and plug in my EAS kicker.
Will report back on how it went.
Cheers

Steve

 

[wammers]

Found it under the valve block.
Will leave it for now and see how it goes next week whilst towing the tin tent.
Has only faulted once since last August and that was on a long trip.
It was
"pressure signal constantly high".Took most of the connectors apart in the EAS tray and sprayed contacts with contact cleaner.
If fault happens whilst towing will pull over and plug in my EAS kicker.
Will report back on how it went.
Cheers

Steve

Cleaning the contacts possibly rectified the problem.