Recent content by Liam Deeney

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
  1. Liam Deeney

    MPG <> Everything

    MPG <> Everything
  2. Liam Deeney

    Two questions. MAF and weird connector

    Hi all. Been a while been cracking on with the 1999 P38 gems 4.0 - was pretty sure the MAF was dead so got a new one. Just plugged it in and got 0 lb/s - is the wiring dead? Same on old and new sensor. All other readouts are good. Usual MAF issues like misfire under heavy load and grumbly idle...
  3. Liam Deeney

    What did you do with your Range Rover today

    Restored the steering wheel - finally got a good colour match and it now looks brand new. Last few weeks I've re-painted the rocker covers and refitted with new gaskets, removed the air compressor and tank as I have springs, added more wiring to improve battery charging (and cleaned all the...
  4. Liam Deeney

    What did you do with your Range Rover today

    New steering damper, anti roll bushes and links, air filter, pollen filter, cruise control vacuum pipes replaced, locking wheel nuts replaced, wheel nut set put on (had some 28mm some 27mm??), Bolt drilled out in exhaust and replaced to stop really bad blowing, new steering box, unceased rear...
  5. Liam Deeney

    Lumpy gearbox fixed (oil change)

    If you're getting a jerking, lurching sensation when changing gear (2.5 v6 jatco) in an auto then i suggest changing the oil. Provided you can get the plugs and official oil it's super easy and the fl1 now changes gear like its out of the factors. You'll need a 24mm and 14mm socket which not...
  6. Liam Deeney

    P0340

    Leason learnt. Don't work at night tired. Had another look today in daylight. The old rubber o-ring was stuck in the manifold. Didn't see it as it was blackened. Took it out, refitted the new sensor, error gone and car starts instantly again.
  7. Liam Deeney

    P0340

    I'll have a dig. I did take a lot off the top when i replaced the thermostat. Ergh.
  8. Liam Deeney

    P0340

    So how can it start if i'm getting that error? The car starts every time and seems to be running fine?
  9. Liam Deeney

    P0340

    OK - a frustrating problem on my 2004 KV6. Saw the error P0340 on my OBDC after doing a thermostat swapout. Accoring to the Rave this is "0340 CMP sensor Open circuit/no signal" it also states that the engine wont start and that there will be a warning light on the dash.... the car starts and...
  10. Liam Deeney

    Freelander 1 Injectors....

    Just a word of warning that on my V6 I was removing the injectors and on one, and one only the bottom half detached and remaining in the intake. Easy for me to get out with plyers but not a fun thing to happen.
  11. Liam Deeney

    Freelander 1 V6 connector and possible missing pipe?

    Awesome. Thanks for the info - glad I didn't screw it up!
  12. Liam Deeney

    Freelander 1 V6 connector and possible missing pipe?

    Glad the connextor is for something that isn't there. The little connector for the pipe does appear to be on top of the gearbox. Should it have a hose if it's a breather?
  13. Liam Deeney

    Freelander 1 V6 connector and possible missing pipe?

    Forum auto changed my link. Should work now. Its not got cruise control.
  14. Liam Deeney

    Freelander 1 V6 connector and possible missing pipe?

    I've recently swapped out my thermostat (supprise supprise) and done the manifolds, fuel rail, injectors etc. To resolve a misfire. When doing it I found a connector that wasnt plugged in - its a 5 pin connector with 4 wires that seems to come from directly below the battery holder - it has the...
  15. Liam Deeney

    Me again... pins pulled out of ODB2 Connector

    Thanks all sorted. put the correct colour pins in the correct place from the diagram - got an odb2 bluetooth adapter from ebay and am using "Torque" on my phone. Awesome!
Back
Top