Search results

Hello guys, I might be on the way to remove the ACE system and install the standard ARBs. Reason: recently, in a curve a rusty pipe blown and the pump was seized. I would have few questions though: I already removed the pump and installed an idler pulley. The car seems to have a small amount...

Hello guys, I have a question about a Defender TD5 After blowing up a turbo and almost blowing the engine, we ordered a new turbo, we clean everything and we started the engine. Everything looks fine but: 1. New turbo has 15threads on wastegate rod. 2. Maximum boost I got in a hill is 212kpa 3...

hello guys, as I understand, buying a new SWO500030 doesn't make sense? It will not fix the problem? sierraferry, this problem is only in connections, not in the switch itself?

do you think I can't go wrong with playing to wastegate 1 or 1,5 threads? I don't have EGR anymore, and my D2 is EU2, so no cat inside... regarding MAF, I also own a Defender td5, and also the MAF is dead, but the DEF drives well, the pressure is rising easy to 230kpa, with 11 threads the only...

ok, I looked the input fueling in Nanocom, and the best I got is: Ambient | Manifold pressure | turbo pressure 97.30 kpa | 221,61 kpa 98.36 kpa | 222,21 kpa 97.51 kpa | 221,33 kpa 96,26 kpa...

hey guys... after playing a lot with waste-gate, trying to raise the boost (1.1bar only reached) I found out that my car has the Waste-gate solenoid bypassed... Changed the solenoid, connected the pipes to their correct places, now I have OverBoost. I started to undo the waste-gate actuator, so...

few days ago I noticed that my tailgate is not locking... I removed the trim to check out the latch mechanism, nothing strange there, when I push the buttons, the motor tried to move something, but looked as it has difficulties I cleaned everything with gasoline, sprayed with WD40, the latch...

Hi again, yes, I've seen the way to repair the switch, but, before unmount it, I just wanted to check some other options as well... here is what I noticed: first, I added 600ml of transmission oil in the auto gearbox. then, I've read that it is not bad to overfill a little the gearbox, so I...

hey guys, have you solved this issue? I now have similar situation sometimes... after I drive in Reverse, M + S lights start flashing, and it looks that 1st and 2nd gears are not working, it seems that the car starts driving in 3rd already (due to its rev and power). If I turn off engine and...

I sent them a request already... Waiting to get their answer. Actually not, I tried to tighten them so, and the nuts started to create their "own" holes into the rims, however, I cannot proceed further, as the rim won't be centered in this way. Does anyone know the measurements of the holes...

hey guys, first of all, I'd like to know the manufacturer of the modular rims in 1st post? then, I have some issues with Terrafirma Modular Wheels for D2. Here are some photos: As you can see, I have Terrafirma wheels, and genuine STEEL nuts. But the Taper of the nut will not come into the...

ok, but I measured the pressure in both hoses (before Fuel Regulator and after it) so I think the pressure should be below 4 bar? anyway, I am not saying that this is the problem for not pulling, that's why I asked you, maybe you know more about that

hey guys, I know the thread is very old but I hope that you will get notified about the new message here... I have some troubles with my Def TD5 too. The engine has been repaired 20000km ago, and after repair, the engine loses power... low RPM seems to have loss of power. I measured yesterday...

Hey Mark, Can I ask you how should I take all the air out from the system? I mounted my Eber same way you did but I am getting the 014 error from the heater. It says the air inside and the heater is not working properly..

hello Mark, I have read your thread about Hydronic and I installed it as well as you did. Unfortunately I am not able to connect correctly the water pipes. Can I ask you to help me with a diagram of the pipes? My Eberspacher is a Hydronic D5WSC

I also don't see any pictures. is it possible to re-upload them?