Search results

A problem that affects piston ring is high temperature causing considerable damage in its structure ......briefly if the engine was overheated for a period of time, likely to be damaged piston ring ....

.....or a supercharger :D Untitled Document

....if you set the multimeter at 200k ohm it should be at 02.2 -02.1, it depends on the sensor... I do not know if it fits that sensor bmw 1732566.....this is the genuine Camshaft Position Sensor - Freelander 1.8 Petrol - Genuine Land Rover at www.rimmerbros.co.uk repeat ....depends on...

Test for resistance by setting the multimeter to ohms,if resistance is infinite or 0 ohms, replace the sensor. Infinite resistance indicates an open circuit in the sensor, and 0 ohms indicates a shorted coil in the sensor. The sensor must be removed for resistance testing with a multimeter...

If the CMP sensor signal is missing, the engine will still start and run, but the fuel injection may be out of phase. This will be noticeable by a reduction in performance and drivability, together with an increase in fuel consumption and emissions.

........Fit on a freelander

If you study the basic engine specifications listed for the 120 and 135 PS engines above, you'll note that there is just one difference between them: the cam shafts. The cams in the 135 are a good deal warmer: 0.7mm more lift and a much longer open duration. The consequence of this is an...

This is the new BLACK SPIRIT :rolleyes:

Freelander........ probably the best in his range ....always when i drive makes me smile :D I like this picture...always on their own

....it is best to remove all hoses and clean them individually, it is more work but worth it ;)

....or Throttle Position Sensor

Clean propeller shaft flanges and mating faces. With assistance, fit propeller shaft assembly in position, support front and rear propeller shafts at each end. Align viscous coupling support bearings, fit bolts but do not tighten at this stage. Position propeller shaft to rear axle and...

http://www.landyzone.co.uk/lz/f69/rear-diff-mount-replacement-how-guide-101774.html

What is so hard to measure pressure, disconnect the fuel pipe and connect a pressure gauge ....

....if you went with a low level of petrol in the tank could have burned pump ...check the pressure fuel ramp in the priming and starting.... should be 3.6 bar

....what type of thermostat you have ??? ....is this PRT thermostat it is a upgrade for k series cooling system .....mostly problem comes from the thermostat.

....i love this stuff :rolleyes:.....what is A-bar ??

Modified engine shield,...last time I put in four screws provisional caught... ....now is permanently...6mm thickness

.....crankshaft is balanced???,.....if not balanced should be sent to a company specializing in such operations

:5bcheers2: ....You're right, MEMS 1.9 does not require oil temperature sensor....