Search results

Sounds like backinblack is talking about a BLTouch levelling probe?

I hope so, I've ordered the parts cannon to be fired. Had an hour or two the other evening after work so instead of fixing the nunmerous and glaring issues with the body and the brakes I decided to make myself a poor man's CDL lever. I milled a 10mm slot in some aluminium flat bar to go over...

I'm not having much joy with these brakes. I've bled them on the pedal, and several rounds of power bleeding with my foxwell diagnostic tool. I can get a fairly firm pedal but as soon as the engine is on/booster is working the pedal goes to **** and slowly creeps downwards. Driving around and...

I think you mean the rusty side :p

The reservoir goes with the chassis and the rest of the steering gear though so it makes no difference until you start swapping parts over? :D

You could do it over a weekend or in a day if you were determined

She made it home, gents. Bare minimum at the moment though, no interior or carpets. I'll be working on a DIY CDL linkage in the coming week and I'm going to need access to the top of the transfer case. Shortly after I left work I found I had bugger all brakes :eek: but I've discovered my...

Howdy, Thought I'd put down in writing the things that with hindsight would have made doing my body removal a lot easier. I had some good advice from @steve24v on my project thread that covered a lot of this but I did find some things weren't necessary, or needed mentioning. This probably has...

It's screwed into the top of the dash, next to the a pillar,just for information's sake, I'm not interested in tuning or anything Only got a plastic line here I'm afraid, but thanks. Thanks, I might make some solid lines to replace the flexis then, good idea. As for the clutch damper, I...

It’s for the capillary tube on an analogue manifold pressure/boost gauge

My friends. I have made a terrible discovery Ahem. :D I bet nobody's ever thought of that joke before... Put in north of 14 hours today to get the old girl back together, with the kind help of one of my colleagues and latterly a length of 2x4, she went but there were...

You bought a toboggan?

Cool, what filament did you use, and have you had problems with high temps?

Narrator: and then he did. I think... I think it's ready to go back together?

Got some time to work on the car this evening, it's getting there. Changed the CDL switch. It broke immediately. Cleaned the old one out and put it back in. Now it works. Yay. Spent a good hour trying to hoover all the dried mud and stones out of the old section of chassis. This is the...

I thought I'd show the missus a good time today after work, it being valentines day and all. ;) For some reason though, she didn't find coating the whole chassis with Tetrosyl Stone Chip very erotic and didn't even want to play with my new Sealey underbody coating gun. :oops: She was also not...

You are absolutely correct, it's been weeks of late nights and weekends spent toiling in the workshop, followed by staring at my bank balance. And quite a lot of rocking forwards and backwards in the corner. Made some brake lines and got them in with new clips. I used just a squidge of tiger...

I have considered it, and to be completely honest, I'm trying not to think about it :D There's a small hole on the OSR wheel well up near where the outrigger goes, and the inner wing up by the driver's feet is pretty ropey. At the moment I haven't got access to a welder that wouldn't blow...

Should work on mac, it works fine in Ubuntu :cool:

Are you on mobile or PC? https://www.landyzone.co.uk/land-rover/image-upload-problem-workaround-on-pc.383972/