Search results

No longer available. Sold.

Offers? If no offers, before Christmas, I'll contact the scrap yard, tis a shame to see the old gal go to the scrapper...:(

Reduced....£550.00 ono

I've owned this gentleman's conveyance, since 2008, it was my daily driver up until I last MOT'ed in 2016 for a family wedding it was then laid up. I had always intended to put it back on the road, but with one thing and another it never got done, I now own a Disco 2 and have just purchased a...

Prefer if it's working (mine is a SRB 101241 01 020440 model ) but if it's not working as per spec I'm not that bothered... 2001 model Anyone have an old unit sitting on the shelf? Please.

This is what I'm basing my request for help on, Land Rovers own Workshop Manual:

I'm fully aware of the reputation of some of the Britpart parts I've use enough of them in the past, I tried obtaining a better make but couldn't, not at a sensible price. My understanding is that the 3 amigo's could/maybe triggered if one of the one-way valves or solenoid valve in the ABS unit...

A brand new master cylinder (ok a sh**part one), but the old master cylinder would occasionally by-pass pressure (allowing the pedal to drop) and the 3 amigos would come on, if I turned the ignition off they would clear for a while, then return when the pedal pushed through again... I'm thinking...

Unfortunately I've tried that including stamping on the pedal, braking distance isn't that good I have put best part of 3.5 Litres of brake fluid through the system so far. I wouldn't want to even try HDC, with the pedal drop at the moment. And I certainly wouldn't put an empty trailer on the...

I've replaced my brake master cylinder, I tried bleeding the brakes (old school) NSF, OSF, NSR and OSR, if I pump the pedal its hard/solid when the pressure is released and re applied the pedal slowly goes to the floor. I'm thinking it needs power bleeding to remove any air in the ABS Unit, is...

There's always the hot spanner as a back up....:)

I have now fabricated and turned the hydraulic press/arbors for Disco/P38 steering axle ball joints, seems to work well enough.. with a 30 ton ram....:rolleyes:....:D PS:- Anybody who is faced with replacing the ball joints and they don't have tools to press them out/in, I maybe able to help...

Order and fit new rear air bags....sorted. Takes about 45 mins per side, with a set of axle stands, a 3 ton trolley jack and 2 cups of tea...:)...

My 2001 disco failed the MOT on anti-roll bar ties and front axle knuckle ball joints last week, I replaced all 4 ball joints and anti-roll bar tie rods. Not a bad job really just done a bit differently.... Now I've done the job once, it's time to make a proper hydraulic removal/installation...

Keith. How much would you want for it???

Not sure maybe someone with more disco knowledge could advise us? I believe mines pre face lift.

Alive just

Its been a while since I've been here, so out of touch with the forum, life gets in the way at times... I'm in the need of a front plastic bumper for my Disco 2, does anyone have one in the Chesterfield area, willing collect/travel up about 80 miles, so Birmingham, Manchester, Lincolnshire and...

Have you tried "Foley Specialist Vehicles" near Harlow in Essex......01279. 793500. They build/prepair vehicles for safari, special vehicles, television work and they used to deal in all military vehicles when they were in North London.

What was the batteries voltage before charging?