Search results

Hi welcome, should be able to get a very good one for that budget. What year/model/engine is she after?

Evening all, did some work on the bumper today, mitred the ends and cut some corner bits which still need finishing off. I've decided to use the standard bumper lights so measured and cut out the holes for them (measured once and cut about 3 times to get it right :D). Then made some brackets to...

Hi, think it's offside front of engine block next to the injector pump. Might be covered in oil and crap. Got any pics of your 110? Steve

Funnily enough that's the ones I had to change. Fitted standard ones in the end If you go for poly bushes, there are different grades (hard to soft). I think the colour had something to do with it (red being hard and black being soft, but don't take that literally, just an example). My 90 had...

If you are going to rebuild your original calipers then I would get some cheaper ones for now. look on ebay, I just bought some for my disco with a 2 year warrenty. Make sure the bores havnt rusted up in your calipers before you get the rebuild kit, might be a waste of money/time if they can't...

Best to look on YouTube for how to do electrolysis rust removal, it's very easy to do. Basically get a big plastic builders bucket (has to be plastic) and fill it with enough water to cover the metal part. Add some washing soda to the water. You need a sacrificial piece of metal (I used a bit of...

Hi, main things to check is the bulkhead, both footwells, top corners where the windscreen hinge is and around the door hinges for rust. Rear of the chassis tend to rust so check where the main chassis rails meet the rear crossmember. But check all of the chassis anyway for rot. All this can be...

https://www.ebay.co.uk/itm/272405796803?mkcid=16&mkevt=1&mkrid=711-127632-2357-0&ssspo=ym3T3J-NRrS&sssrc=2349624&ssuid=bjwmf33kr22&var=&widget_ver=artemis&media=COPY This stuff is good on plastic

+1 this, it is a clean and cheap way of removing rust. Here's a before and after on some spring cups I did

Hi, welcome The discovery section might be more use :D

Snap

Looks like you're going to be busy soon. At least it will come apart easily:D

That black box under the passenger seat on chassis is the air compressor for the rear suspension air bags, I'm guessing you have coil springs on the back axle? As beneagles says your ace will more than likely be disabled as I would expect a warning light would come on if there's no oil in the...

Thanks, however it depends what your into lol:D

When writing a post, press on the upload a file Then press choose file From there, choose the picture you want and OK it. Picture should be sent to your post. Then you have the option of thumbnail or full image This is the way I do it on my phone, computer might be different though

Pretty much same as bleeding brake calipers, bleed nipple is on the slave cylinder. As for changing wheel studs, I've only done them on a car once, I cut the stud off flush to the hub then hammered the splined piece out with a punch, pressed the new ones in with a vice. Not saying this would...

For the battery isolator switch I had it mounted behind the drivers seat on the bulkhead (only as I relocated the batteries behind the seats) but some people put it on the seat box where the battery is located. I hid a switch in the cab for the stop solenoid, can be put anywhere you want such...

Did another search and found this. This is how I bled the fuel on mine when I put the engine back in on mine. Although I put in a Jerry can worth of fuel. Crank sensor could be at fault maybe?

Check the harness by removing the red plug on the ecu which is located behind the battery. Look at the pins on the plug to see if it's covered in oil. Not sure how to check fuel pressure.