Search results

This site contains affiliate links for which LandyZone may be compensated if you make a purchase.
  1. NZ Pablo

    TD5 runs similar with and without MAF

    Hi all. Since purchasing my D2 it's been 'sluggish'. I kind of assumed they were like that since I have limited experience with them! But I've read a lot on here about this sort of performance being related to the MAF sensor. So I took mine off, cleaned it with carb cleaner. Re installed it...
  2. NZ Pablo

    D2 Td5 intermittent cutting out/stalling

    Thanks Sierrafery for all your help and advice on this (and to everyone else too). Very impressive service levels on this forum!! I wish I could be as confident as you that this is 'end of saga', but given I had 12 months trouble free in between occurances, I'm not sure I will fully relax until...
  3. NZ Pablo

    D2 Td5 intermittent cutting out/stalling

    OK i finally got my local garage to replace the injector washers and seals. Just done over 250kms on it and it has behaved, well, the same as before! Fingers crossed the problem doesnt show up again without warning.
  4. NZ Pablo

    D2 Td5 intermittent cutting out/stalling

    I found another excellent write up of this procedure here: http://www.discovery2.co.uk/Injector%20Seals.html
  5. NZ Pablo

    D2 Td5 intermittent cutting out/stalling

    Understood. Thanks again. I'll report back once that is done eh.
  6. NZ Pablo

    D2 Td5 intermittent cutting out/stalling

    I had some time this weekend so I stripped all the plastic conduit off the wiring so I could inspect it properly. Top end all seems fine to be honest. Ive left it exposed so I can get to it a bit easier at the moment. Newbie question: Is it OK to run without the plastic cover assembly on the...
  7. NZ Pablo

    D2 Td5 intermittent cutting out/stalling

    Update: (full write up for info only!) Car just did it to me again. About 50kms from home. Was running fine. Then after about 40kms, a very slight loss of power at first and almost undetectable roughness at 100km/h. (My wife could only tell because of the look on my face!) Gradually worsens and...
  8. NZ Pablo

    D2 Td5 intermittent cutting out/stalling

    Are they a part I can source individually or do they come with injectors!?
  9. NZ Pablo

    D2 Td5 intermittent cutting out/stalling

    Thanks for confirming.
  10. NZ Pablo

    D2 Td5 intermittent cutting out/stalling

    Followed your instructions and checked voltage across F10 while running. 22.3 at idle. Dropping to 22 or 21 while revving at 2000rpm.
  11. NZ Pablo

    D2 Td5 intermittent cutting out/stalling

    UPDATE: Local mechanic found following faults: We didn't think either of these were likely related to my problem. But we could be wrong! Someone here might know differently? Anyway, this is what they did: AKA not very much! BUT car has been running OK since then. I say OK. It still feels...
  12. NZ Pablo

    D2 Td5 intermittent cutting out/stalling

    Guys you have all been very helpful. I have the car booked in to my guy Monday. Since this list is getting long and a bit like chasing ghosts, I'm going to get him to check for fault codes, and clear them. Maybe blow out fuel lines. Replace filter. Check fuel pump pressure. Basically all the...
  13. NZ Pablo

    D2 Td5 intermittent cutting out/stalling

    OK thanks for all this guys. Very helpful. I've reconnected everything up. I've noticed that the start is now a bit lumpy and occasionally doesn't catch. Car usually starts on first crank. I was reading this other post...
  14. NZ Pablo

    D2 Td5 intermittent cutting out/stalling

    What do people think my injector loom is looking like? A problem or normal? I have no idea. (see photos above)
  15. NZ Pablo

    D2 Td5 intermittent cutting out/stalling

    I mean if it was a problem with those washers, wouldn't I expect to have that issue all the time? Instead it shows up 2 years ago. disappears, and then reappears again randomly.
  16. NZ Pablo

    D2 Td5 intermittent cutting out/stalling

    How about the 2 year gap between fault showing up though?
  17. NZ Pablo

    D2 Td5 intermittent cutting out/stalling

    Thanks guys this is all very helpful. Car is now booked back in with the same mechanics who are the only ones around here with a scanner that can access the LR codes. In saying that though, there weren't any of any concern last time. And the problem was unable to be replicated. Until now! 1...
  18. NZ Pablo

    D2 Td5 intermittent cutting out/stalling

    Think so but will check.
  19. NZ Pablo

    D2 Td5 intermittent cutting out/stalling

    Yep sorry. I'm used to that stuff all being in forum signatures. I see that doesnt happen here. 2004 D2 Td5 Auto. I've intorduced myself!
  20. NZ Pablo

    D2 Td5 owner in New Zealand

    Hi all. I'm a newbie to the Landrover scene. I have other vehicular obsessions but my appreciation/curiosity for Landrovers is relatively new. Having lived in the South Island of New Zealand I got into some 4WDing and really appreciated how those skills allowed me to get to places most people...
Back
Top