Search results

That makes sense: there will be the needed bosses in the castings (Rover Powertrain likely only ever had one casting for all its 1.8 engines at any given time), but you may need to drill and tap non-Freelander blocks to mount the IRD

They look identical to me

The 1.8 and 2.5 have similar rev ranges and torque peaks - hopefully, the image link below works, else you can find it here: http://mgf.ultimatemg.com/group2/engines/engine_options.htm That may mean that the KV6 firmware calibration may be an acceptable starting point?

Tantalisingly close Philip! :D

Any update on this project? :)

I’ve no direct experience with this swap, but the chairs ought to be plug and play. The only consideration is, I believe, the tilt seat mechanism that you’ve already identified.

I know. It's probably daft to create emotional bonds to mechanical things, but there you go...

Brake pedal to the floor is not a mode of failure that I would particularly enjoy :-0 I have way, WAY too many cars at the moment, but it is difficult to find the one(s) that need to go. One MGF is the one that I've owned from new and I don't feel that I can ever part with. The other MGF is my...

Nothing in the footwell that I can find - but there looks to be a pin hole in the engine bay hose that often appears to be a damp area of dust discolouration around it. Maybe I am misinterpreting, but everything else looks good… The stiff clutch is the usual arm humming up in the bell housing...

Wow! And there was me happy with 22p and half a dozen air fresheners…

To be honest, that is the kind of quick and dirty repair I like the sound of! Another approach I thought of was to braze in a repair patch - which hopefully would not introduce too much warping heat into the panel, and then make good with some epoxy primer and a rattle can top coat - which, as...

It has been a while since I last updated on this thread - and to be honest, the poor Hippo has been somewhat neglected recently. Too much "life stuff". Overall, the little donkey has been soldiering on - but I think still has a slow coolant leak somewhere. That is not the only problem. Time...

How's this project coming along Philip? I have been catching up on my reading of this thread - have you got the timing ring conundrum cracked yet? :)

Great looking air intake/snorkle! :D

Hi Nic No, unfortunately not - the think that would be part of the software settings and I don’t think is user adjustable? I may be wrong: if it can be adjusted by yearbook, then it ought to be do-able via pscan…

Hopefully this is going smoothly Philip? I’d get the gearbox/driveshafts in the right location and worry about the engine mount later. Remember too that there are a plethora of K16 engine mount designs for different vehicles - so if the Freelander one doesn’t line up, then an engine mount for a...

I've conveniently forgotten to look at this in any more detail - all my old cars are demanding my attention at once, the blighters! Must take another look and see how deep under the surface any corrosion goes... Thanks for the reminder @MollyNomad :D

I need to do this to mine too! :( Nice bit of fabrication - where did the material come from?

Yes - and of course the MEMS for the steptronic has more output channels. I think I have the MEMS part number codes somewhere…

Very true. Might require a steptronic ready MEMS3?