Search results

I hope this explains id better fro you

I cant really see how much easier I can make it, it's a step by step guide, I have never taken off the sterring wheel, so once the sterring wheel is centred you need to make sure the Pitman arm is lined up on lineing up hole with the pin/drill on the spline before tightening up the nut, then...

Discovery Series II Workshop Manual - 1999MY ON - 6th Edition - Eng Hi all been following this, so I thought I would jump in, so here goes Place the front wheel on tin, I used 2 old biscuit tins, one lid and the cut out bottom with grease in-between on Centralize the steering box, check it...

Its hard to offer any advice with out some photos to show the condition of the chassis

Over the weekend my Insurance renewal dropped into my inbox, was I in for a suprise, last year for my 1999, D2 it was £127 fully comp, this year its...£272,.. that an increase of 115%, needless to say I will not be renewing it with Zenith, I called them this morning to see it the could shed any...

When I did mine I found the edge of the hole was sharp, as was the edge on the new ball joint so I filed a very small chamfer on the sharp edge just to get a start, also it's good practice to put the new ball joint in the freezer for 24hrs before you plan to install them, and gently warm up the...

they look good were did you get them from??

I did not use one of these, instead I very carefully ground down the top of the ball joint until it was flush with the axel then I got my stick welder and started to weld small circles on the top of the ball joint, until it was red hot, I let it cool down just hot to touch, then using a punch...

See attached item 4 is a spacer leave it in, you need to get one of these to get the ball joints out or hire one

When I worked a MOT tester we had a Lady came in she said the car has a weird noise when she pressed the clutch, we asked her to start the car and put it in gear sure enough there was a load noise, so we popped the bonnet and asked her to do it again , once the bonnet was up we soon found the...

I did both mine front and rear, if you have any question PM me

HI I did a post on them, I made my own tool, but you do need a through socket all the info is shown below in similar threads, and to do the big end bush you will need to remove the anti rool bar its not possible to do it when its still on the car

could you not ask them for the Part No and tell them its to post on this forum, for more sales

Gooutdoors have them in the trailer bits section, then any trailer, or car parts shop should have them

The foam on the headliner is what's left of the foam back material , you need to watch a few youtube videos on how to remove the foam the recover it with new foam backed material

Taking your headliner out needs basic tools an takes 2 hoursish, removing a sunroof I did mine in a hour, cleaning,fixing it reinstalling say 4hour per sunroof, cleaning the headliner, 4hours, re covering a headliner 2-3 hours as it needs triming around the edges an holes. Refiting 2 hours...

You need to make friends, with a crew member, who lives in the Aberdeen side of the service, who can handcarry it over on the ferry, for a dram or 2

Strange, I have just been on the website,to ship a replacement propshaft kit to my home, is less than £10, as its only 8 kg, so how much more is it to get to your home

If you swap for a UJ you have to replace the flange it's part of the kit so the old one will not fit the new flange

Jgs4x4, do a conversion kit from donut to UJ, for £134ish