Search results

Your time doing any education such as A levels was not and will not be wasted. You wouldnt be doing the degree without A levels..... the degree and A levels will cover you for the future, maybe 20 years later... ", I need to learn properly, and quite quickly." Aint going to happen with a third...

I like that, the main loom is 43 years old and very weakened so I may well do that as well, wire turns up tomorrow, just hope I can find the new eyes for it. This is the location, its a pig to get to so glad it disconnects.

Thanks for the help.. I have a load of those connectors, luckily this one has a junction. Thats the wire in question. I measured it about 2.6mm... I only have 2.1mm or 3.3 wire so will have to source some more I guess... Do you think that will be 2.8mm wire ? The fuse is 20a so I suspect...

Wowzers deep stuff.. I will measure existing..I will be honest its a smidgen fatter than the 8amp I have but about 1/3 smaller than the 20 amp I also have.... Problem is I have no idea how long the wire is from source... assume its pretty much a car length.... This spur off the main harness is...

Non Land Rover - I have a fuel pump harness which is knackered. I have some wiring from Halfords which is 8 amp. My fuel pump is 7 amp. Is that ok to fit or do I need to go a lot higher ? Is there a chart anywhere for UK sizing amp vs wire size ?

Yeahh lots getting cancelled at the moment due to the state of the ground.

https://www.clickmechanic.com/price-estimates/land-rover/defender/clutch-replacement

So ChatGPT, what is it ? An AI based Q&A session which is free (odly) and often called out for mistakes. So at work we have a director who is very good and she is also very non technical. They have this thing where they have to give a talk on something new they did that month for a couple of...

and the socket adaptor :) I like the posts :) I have one of these but have never used it as I purchased before I did the job and its still sat in my garage for next time which has never came.

Its a chemical process when the ally touches steel, you should be able to put a membrane or anything between, they should be treated but some better than others. Most just live with it.

May just be a drain on it somewhere, 5 mins drive wont have added the charge to cover the jump start. Get a volt meter on the battery so you can see the before you start voltage and see overnight etc. If you started the day literally with enough juice to crank it then did 2-3 stops I can see...

My fave hobby as well.. Welcome, awesome pictures...

Pic Measurement Guess Psychic I am afraid are the only options.

15-20 secs for the glow plugs.... wtf.... if you are in the arctic......

I would be guessing but I would be VERY surprised if anyone could stand by a warranty on a vehicle which is written off. There are so many unknowns and risk which there wouldn't be any appetite for.

webbed I erd anorl..

Top job, this is on my list as well... I would be interested in the timings for the efforts. How long to lift the tub..... How long from that until engine remove ? How long to remove stuff from the chassis... ? Just ballpark...

Agree, get him setup and it will keep him busy for 5 months... just keep relisting for free and it doesn't matter if it takes 3-4 cycles to find a buyer.

Eeeek Expensive : ( https://www.velarforums.co.uk/threads/timing-chain-at-44k.4360/

Eh ? Whats dumb about stealing something you can sell for profit ?