Search results

Heater plug light staying on? Thoughts?

I've just got rid of the vibrating noise that appeared the instant I drove out the mot station. Took the rear prop off in the end and it went, put it back on and it's still OK. New one now, sounds like a dry bearing whining at the back.

Very good

Has a felt covered inside one. Paddocks.mtc 8473

Tyres need balancing. My wobble comes in at 55 goes at 58.

Haven't you got long arms :D

Interested! Mine has all split around the tunnel where its thin.

Id use all 4 fixings in the seat base . If you tried going backwards and forwards with just 2 fixings, it tends to crab along the runners putting strain on the nylon that holds the ball bearings in the runners.

You know it makes sense. ;)

It's great stuff. I did the engine bay and the inside floor of the tub.

I had same problem but mine was push rod length and you've already tried that.

Is its nickname Christine by any chance ?

I only used it to work out what wires do what and still managed to get it wrong.

Fitting a rrc rear seat is also an option. Good old fashioned bench seat.

Nothing horrid about comfy, bum hugging heated seats.

If you go on you tube, rx8 seats into t3 vw. It give a good clear wiring video.

If all else fails, clamp two sets of mole grips on at 9 and 3 o'clock. :D

Only problem I found with this is the rails tend not to move together and tend the crab along.

Then we're getting into the mysterious world of hexagons and the like.