Search results

Well that now makes more sense. Just buy standard avoid ****part

Send your cctv to the plod hopefully they do him for something, fix it your self or leave it as is its hardly structural

You don't need to buy anything for 20mm extra height. Then again I don't understand why you would bother doing anything for such a small increase in height in the 1st place.

Seriously.....you felt the need to comment on my obviously humorous comment.

If you can't identify a broken Bush please give up your keys stop driving and use a bus.. Poxy auto correct.......now correct statement

No no no I just can't do it......iv worked out a route from my mates place to mine avoiding ulez cameras and out again avoiding ulez so instead of going there and driving it away from the zone it's comming home for its full valet check over and I'm keeping it for now to use as my shooting car...

Bugger, that'll teach me not to read the whole thread. Hope you get it sorted start by checking hoses make sure non are split or loose

Why ?? Just why ?

The chip for the car is in the case not on the circuit board have you tried putting the old fob case inside the car ?

It's a 10 year old post don't expect a reply anytime soon and hast been here since 2016

You can't miss align an ace pump it only bolts into one place. However it may have the wrong pulley wheel on it.

Move along

Send me a pm

Your battery is dead you wasted your money on the hpfp, get a gap tool code reader nothing else will do. As above if you don't have a good battery these D3s don't work

OK do the aircon fan mod

Permanently sort the issue. If you had fixed the leaks your pump would not have run dry and died. The ace bars will just lock them self's you will not be able to get rid of the red warning light on the dash unless you reprogram the cars ccf.

Just fit the belt from the non ace car thus by passing the pump

You may have a spun bearing.....look here for more info. LRTIME on youtube

You should start your own new thread and not tag onto the end of an old 2019 post.

Make sure your height sensors didn't move 180 degrees if there all good you mite be in a hard fault condition which needs diag to reset