Anyone had this issue my temperature gauge does not move, fitted new ect because fan kept coming one, got voltage to sensor so no broken wires? Thanks

Strangled that cleaning maf made improvement for a while, but map sensor ended up being main issue, replaced with new, good as new

Faulty map sensor cured fault

Hello everyone, had a good look around but still not joy! The EML comes on then goes off then comes on and so on! Causing limp mode :( not ideal for a young man :) Fitted a new coolant temp sensor because revs were fluctuating and fault came up indicating this(that's sorted) the diagnostic...

Ha ha I wondered that when reading the fix, hopefully this will cure my similar issue, although I thought I may have knackered my maf through over cleaning :)

Found pump itself was leaking stripped and made new gasket, hope it lasts :bump2::eek:

Belt is ok, think I may have a leak somewhere but struggling to locate

Faulty maf sensor turned out to be problem

This week I noticed a whining noise when I parked up when steering, so checked pas fluid, level was ok, checked later when day light noise not present. Now I went to use tonight for first time in 2days and steering very hard to move? Anyone had this issue? Thanks in advance :)

Yeah all done thanks for reply :D hasn't caused you any issues then?

Removed and blanked egr and cleaned maf sensor hopefully eml stays off :D Tomorrow oil change and new coolant sensor:rolleyes::rolleyes:

I've removed egr valve and blanked off exhaust and inlet also joined the coolant pipes! Have I done the right thing? :confused: :confused:

Any ideas where to start looking, I've cleaned maf sensor and remove and blanked off the egr valve.

I'll be doing the same soon! Sounds like you might have hit them too hard, should spin freely! They will free up tho.

Yeah after a few weeks and taking prop off, I managed to feather clutch pedal and very rarely get judder now, just worried when I crawl underneath to fit prop (and struggle) I won't be taking off again 10 mins later. Thought it was originally when cold (oil or something causing slip). I do like...

Thanks for replies, seem to think this will be the case! :censored: :censored:

Became freelander owner 3months ago. Hoping someone can help, I have a freelander 1 with intermittent judder when pulling off, I removed vcu to see if fault went away, unfortunately not but its a lot less severe. Servicing vcu at present, want to refit but don't want to cause more damage...