Three 1L bottles of unused Castrol ATF DEX II. Location: Near Exeter Price: £15 + £5 postage (RRP £7.99 each)

Thanks, much appreciated :)! I always think when I walk past a barn that doesn't look like its been opened for a while, hmm I wonder what's in there! A chap met my old man yesterday from the rover guild, he looked up the chassis number and he's infact 1962 not 61! Now just the case of sending...

Thanks for the replies everyone, much appreciated :)! Chassis paint was por-15

Ta :)! The other car - an Austin A55 cambridge estate was so rotten it was half sunken into the ground. Think it was because it was half outside.

Wasn't sure which section to put this in, thought this was the most relevant! Thought id chuck this up here for anyone whos interested to have a look at. This is a barn find me and my old man found in 2011. This is copied from my local forum from over the past couple of years, so forgive some...

1. '53 Series one 80" (still got) 2. 300tdi discovery

Ta, got a new cv for it and reassembled. Much better now :)!

Ok thanks, I've not got pins with my refurb kit :S... Just stripped it down and they look fine anyway.... Next question. Took the ball off, here's it's condition; I'm thinking this damage doesn't matter that much as this should be a none contact part when reassembled, the area where it's...

Osram night breaker plus bulbs are very good if you want to change the bulbs. Dont know about xenons.

Thanks :)! No matey who I bought it off did it. Certainly unusual!

Ok thanks chaps :)! Good idea about the wheel bearings! I assume i'll need swivel pins too? Just want to get my shopping list so i can get it before i go to the parts place tomorrow.

Thanks, shims removing where? Ive not taken one apart yet so dont know my way round them very well. No its not, i first noticed an oil leak from the swivel ball. And rocked the wheel and you can see the play is there.

Sorry if this has been covered 10000000000 times. But i couldn't find a post relating to my query. My swivel bearings are knackered as my wheel moves loads (oooops), but my swivel ball is looking in good condition still. So could it just be a case of replacing the bearing and pins? Dont want...

Pm'd

Bump

Roof rack up for sale as i bought it with the intention of shortening it for my discovery, but decided its too tall for what i use my truck for. In good nick, no dents etc. Only bad bits are some rust where the coating has come off (pictured). I don't have the fixings for it to fit it to the...

Ive got one, my plan was to shorten it, buts its too tall for mine, as i use it as a green laner/off roader. I dont have fixings, although i could make some if you needed them made. £60 without fixings. In devon.

Ta :). Got a bit more work done tonight, slowly chipping away at it. Ran out of axle stands.... Hmm, this'll stop it falling on me when the jack gives way :D! A hole. Where rust once was. Not the best welding but it's solid Ground back fine In other good news spoke to...

Some more pictures of a patch I cut out and welded in tonight - you can't say I'm not good to you lot :D! Went better than the other side, used a magnet this time! The offending article Moving swiftly on... 2.5mm mild cut out and in position Welded! Had to stitch weld the bottom run as...

Thanks for the tip :)! I've got a welding magnets in the garage, one of them red ones that you can do different angles at, I just thought I wouldn't need it. Ah well live and learn. Thanks for the heads up about the parts jai_landrover. I'll try and think of any bits I need and I'll give you a...