Just pull em out with a screwdriver/pliers

To remove the wheel arch mouldings I used a fine jewellers screw driver and pushed the centre of the rivet through its body. It allows you to pull the rest of the rivet body out. Dave

As the title says, looking to convert my 110CSW to a van rear for my business as i had to get rid of the van (mot fail). Colour not a problem just ideally straight. If your interested might swap my CSW sides for van sides. Thanks Dave

Bit over the top just to change the matrix! Sharp screw driver and hammer. chisel heads off rivets on top of heater matrix. disconnect heater contorl cable. Bend up top of heater box (fiddly but doable) Remove old matrix and slide in new Bend metal back down and refasten with self tappers...

Def snapped end off ANR2994 tie arm +nut and washer 1/2" unf lock nut About £20

Drain tank thoroughly and flush lines with clean fuel should be ok Good electric fuel pump in existing line. I had to put a return line on mine as the carbs were overfueling/flooding. Dave

No You need to buy or make adapters from the V8 mountings to series mountings on the chasis See thread here http://www.landyzone.co.uk/lz/f42/v8-engine-mounts-176959.html Dave

As far as i know they are, other than the top ones on defenders being drilled to accept mirrors.

This makes it easier

AVR automatic voltage regulator? sometimes used with mobile phones?

nothing really just helps us to help you if you can give as much detail about set up as possible. Genuine leads, rotor, cap? if these were suspect it would probaly just run ****e unless the carbon bush in the cap has gone! points or leccy dissy as we've now found out. Taken cap off and checked...

what dizzy fitted? DLM8 with ignition module? So many variables that require more info. Mine wouldnt start t'other day, ignition amp on side of dizzy goosed. New amp reset timing and it goes like **** off a shovel now. Dave

Photos are here http://teninchwheels.wordpress.com/2012/06/06/an-appeal-xsy-647/

We need more info from the OP, the picture they have posted is the same as the #bay listing picture. If you check the revisions on the listing it shows revisions back as far as the 9th feb so may have been stolen from the car lot. Why they havnt ended the listing further deepens the mystery...

The seller has revised the following item information: Date Time Revised Information 09-Feb-1219:54:02 GMTDescription Gallery PictureURL: Pictures Added/Deleted 10-Feb-1219:30:27 GMTDescription 10-Feb-1219:33:10 GMTDescription Advertised price 13-Feb-1210:11:09 GMTDescription...

arent these 48 spline so wont fit early 110/90?