Yes I’ll have to get my friend till plug in is LAUNCH code reader it does live readings so that will most likely be next week

It’s possible it could be the rear but doesn’t make sense because the abs was working fine until I done the front end up. Here’s the link to the one I got...

I replaced the front left one with a new one although it was a cheap one but it’s the same issue. Could try swapping but I doubt it’ll change. Unless it is really the rear right that is bad after all who knows!

okay so I’ve replaced the sensor and it didn’t fix it unfortunately. So the voltages for all the sensors are at 2.21 for the rear and 2.23 at the front. The front left isn’t showing wheel speed it just stays at 1.7kmh

The new sensor should be here in a couple of days so will report back if that was the problem or not. Also my mate used his launch code reader and it read it as front left as well

It makes no sense to me at all because the 3 amigos turned on as soon as I pulled the discovery out of the shed the day I was done working on it and I only worked on the front end never even touched the rear axel

So from what I read in nanocom the 2 sensors are switched but the fault is correct for the front left sensor? It’s 2003

No not yet need to order a new sensor and see if that resolves the problem

Had me really confused! I assume I just need to replace the sensor and it’ll be sorted. Because I’ve cleaned the sensor and used compressed air to clean all the the teeth on the abs ring which are nice and shiny

Hi everyone. I’ve only recently acquired a discovery 2 back in December which has definitely been a learning curve for me because it came with a bundle of new parts to go onto the front end which consisted of upper and lower ball joints, springs and shocks so it’s basically got a whole new front...

I think you’re maybe right about it being a a glitch. Thanks

Hello all. I’ve been having an issue with my abs for a while now which i believed was down to me replacing the front ball joints and of course removing the abs sensor. But today I got a chance and had a look into it. It says on nanocom that it’s the front left sensor so I took the wheel etc off...