It has an alternator. I’ll have to see how it flows and remember how it all goes back together. Thx

Thanks. Digging through the manual and getting some spanners out of the box

Makes sense… process of elimination. Do I have to release the tension to take the belt off? How?

Evening. Just got back from a little gravel road exploring in our mountains with my 1974 S3 and am now hearing a rattle from I think the fan belt… it is noticeable at idle when the belt and pulleys are still spinning. Other than the noise it’s driving/handling fine. How might I fix it or is it...

Found it! Maybe I ordered the wrong stuff. Unless the this fits on the bottom of the DOOR and what I got fits on the FLOOR. Will sort it out. Thanks. Time to study these parts pictures more closely.

I do but I must have looked at the wrong page… 2H 02 group L body rear body 88 in Shows only two parts which I ordered 330271 and the rubber. But the images are so small I could be led astray. Can you steer me to the right page? Thx

Looks like I need to order the last right angle bit. Thanks!! This community is the best.

Evening. I’m tackling the next small project as I start to make my 1974 Series 3 SWB mine. I removed the thoroughly rusty/crusty rear door sill plate and rubber (?) underlayment. I then cleaned it up and repainted while ordering what I think are the right replacements from Rovers North… but...

Just wanted to say thanks for all the helpful advice! I just finished refreshing the interior floorboards, bulkhead, pedals and levers with new paint & rubber. The prep is always the hardest part and removing the bulkhead liner was the worst, but Goo Gone proved to be the most effective and...

Thanks. Can you sand aluminum? Would be easiest to get down to bare metal all over? But don’t want to compromise anything… I figured the footboards are a good training project (flat, Small and under the floor mats anyway) I like the idea of the silicone caulking around the edges.

Thanks… makes sense. I have the floor mats so now need to figure out how best to get the glue off and paint the floorboards!

Evening Can’t stop peeking… finished painting the pedals and added new rubber on my 1974 Series three, but wanted to look at the floor boards as they had some galvanic white powder on top and wanted to check out the chassis under the feet… they were easy to take out and found the chassis with...

Evening Can’t stop peeking… finished painting the pedals and added new rubber on my 1974 Series three, but wanted oi look at the floor boards they had some galvanic white powder on top and wanted to check out the chassis under the feet… easy to take out and found the chassis with normal surface...