So the possessed saga continues. I changed battery and everything was perfect so I thought, And then same things started happening . Now I have the same as before but to be more exact now if I turn lights on the car goes mental. Lights off everything fine. Lights on gear level selection...
Hi
Quick question how do I get the light switch out on a 2008 rr sport . Its the switch and dimmer in a small square panel . Does it pop out ?
Any suggestions would be great
Thanks
John
HI
Thought I would shed light on the possessed Range Rover sport. Had a lot of advice on different forums and facebook and took the battery to get it tested. Even though it showed 12v it ha=d failed inside and had no power. Not sure how that works but I replied the battery and very issue I...
Going to attack the earth cable. Ive not been under yet but any pointers as where it is as battery cable just disappears down the back of battery.
Progress
Fitted new brake switch and done nothing. Checked all light bulbs. Have just measured for voltage from negative terminal to body...
Thanks. Ive a new brake switch to fit and an earth leakage testing kit so attacking the possessed beast tomorrow
Seems to be when lights are switched on or auto then I can select drive without foot on brake. Also lights off everything ok lights on nothing works as it should
HI
Any thoughts on the following . The issues started in this order
1st Rear tail gate kept opening on its own and at same time had every light on dash light up for transmission failure and lowered suspension. Tail gate switch was broken and full of water which has been changed now and this...
yes the one on car failed mot as its hanging off basically. Rover give a 10 week lead time to order. Going to get one from Lithuania as car now stuck in UK with petrol tank hanging off
HI
Any ideas what the metal floor strip is called. Its kind of brushed steel says landcover. Its the floor strip on entry both sides of the car
range rover sport she 2008
Need to know where I can order replacements
Thanks in advance
Forgot to say timing i have just set at the far end of what i can turn the camshaft to. Should i try changing this to get it running smoother ? Ive messed about a bit but doesn't seem to do anything
HI
So I've just started running it in today. Could it be that I need to run the new rings and piston in for longer to get them seated properly as there seems a lot of smoke coming out and really don't want to have to start again !!!!!!!
Thanks
HI
Recon head and no exhaust is fine. Im running it in so the question is during run-in would the pressure be more while the rings are seating properly
thanks