1. J

    Picture of unidentified part

    yes I think it does, thanks
  2. J

    Picture of unidentified part

    Hi All, can anyone tell me where the part in the picture goes?It was in the plie for the back door when I stripped my series 3 18 months ago but I cannot remember where it fits, TIA
  3. J

    Temperature gauge in the red on start up

    Hi, I have just finished the rebuild of my series 3 with 2.2 diesel engine. When I started it up all was fine but once on the road the needle went into the red. It is not boiling up so I think it is electrical? I swapped the temp sender for another new one and it made no difference. Fuel gauge...
  4. J

    Picture uploads

    Hi it is a genuine safari roofed Landrover with the correct sliding side windows and alpine glass
  5. J

    Picture uploads

    These parts are left over from my restoration any suggestions where they go? I think it is to do with glass fitting
  6. J

    Immobilisers/trackers

    Hi, can I ask advice on what type of theft equipment can be fitted to my series 3? It has a steering lock which is poor and also the engine stop is cable into it. I really don't want a padlock on the bonnet if I can help it, TIA
  7. J

    Picture uploads

    I think I have worked out how to get pictures uploaded now
  8. J

    Picture uploads

    Hi I need help to identify parts that were removed from my land rover for its restoration. Not that good with computers so how do I upload pics? Thanks in advance
  9. J

    Aux switch panel series 3 1974

    Thanks for telling me, but it is asked for on registration to this site. Should maybe be a general area like Tayside, but now amended Don't want it stolen
  10. J

    Aux switch panel series 3 1974

    Thanks for the pic that is the same dashboard as mine
  11. J

    Aux switch panel series 3 1974

    Thanks for the reply. That is the panel I have bought, but my dashboard seems different to the one in the picture. I will have another look
  12. J

    Aux switch panel series 3 1974

    Hi I have bought a AUX switch panel for my series 3 but cannot work out where it fits in my dashboard any advice?TIA
  13. J

    Series 3 Front Door seals

    Thanks for the reply Mine are rivetted onto the frame but the same seals . Just the new seals are very hard and push against the hinges and lock.
  14. J

    Series 3 Front Door seals

    Hi, I hope I have posted this in the right section? I could do with a picture of the front door seal set up please. The set supplied is straight forward with lining up the rivet holes and fitting them, but it also came with a long length of rubber trim. Does this glue on to the new trim or how...
  15. J

    Rear crankshaft oil leak series 3 2.25 Diesel

    Update. I ordered new half seal retainers from Craddocks. These ones have a lip on the outer edge(unlike mine) to retain there seal. It looks like the problem is solved
  16. J

    Rear crankshaft oil leak series 3 2.25 Diesel

    The crankshaft journal is spotless there is also no end float on the crankshaft
  17. J

    Rear crankshaft oil leak series 3 2.25 Diesel

    Hi, I had a rear crankshaft oil leak, so I stripped the engine to remove the rear main bearing cap and the flywheel etc. As per the manual I fitted the split seal complete with the spring first, then the top seal retainer, then the main bearing with the bottom seal retainer making sure the...
  18. J

    wiring for blue wire at indicator switch series 3

    Thanks that the right wire and it is now connected, thanks
  19. J

    wiring for blue wire at indicator switch series 3

    Hi,trying to find the right section for my post? New to the site. Mine is a series 3 1974. I have identified and connected the indicator switch to all the wires on it apart from a plain blue wire. It seems to be from the headlamp flash section of the switch. Appreciate any advice and apologies...