I tested the output of the rhs and its the expected 5v, i have no idea where the sparks came from. As you know driver side is not easily accessible and i have an accessory fusebox. From what im seeing there are no exposed wires that could have generated the spark but i wasnt really seeing what i...

so its been a few days of 3-amigos free driving. the resolution? i sprayed a bit of contact cleaner into the female plugs of the abs sensors and left it over night to work. Same ecu, same sensor! sometimes the solution is easier that we think o_O Long term i would like to replace the plugs...

thanks a lot, i will keep you posted of the progress! tomorrow i will have some time to investigate a bit further, especially the voltage! what im still curious is that the lights come on randomly, almost always go off after i switch the car off and on , the will reset, also noticed that the...

The sparks that i saw where from more than 5v for sure! Will wait for the new ecu at this point

So it was too good to be true and lights came back on immediately. I tried to unplug the hub connector however noticed that if it touched an earth point, there were a lot of sparks. I dont have my multimeter with me but is there supposed to be a live 12v there (Ignition was off)?

hopefully in my case all it was a slightly unplugged sensor! if it is, nanocom through me off course as it was signalling the wrong hub, but anyway... good thing i did not damage the old hub and sensor :D

thanks for the details! So i went to unplug the right side and noticed the plug was not fully seated, so that will surely cause issues! So now i cleaned the plug, put it back together and cleared the fault codes. will try to go for a run tonight to see if the 4 amigos reappear.

Thanks the hub on the other side is only a couple of months old so that is why im surprised there is a difference. The hubs in the rear are a few years old and they are the same as the new one. I think i will need to do some investigating. Also ordered a slabs ecu they are cheap enough 😅

I did not understand this bit, can you please elaborate. I have heard that sometimes shims are required, is this what this is about?

Ok will try to disconnect the right side, see what happens.

yes ok, however i still think that when stationary those values should be the same.

yeah, seems like i do have a mix up somewhere. reading live data i get 2.19V on all apart from the RIGHT side which is 2.21!

well as usual, you re right lol. even though i got a left sensor error, reading the live data while stationary shows that right side to be different from the rest. still within range as the others @2.21V but the rest are all 2.19V. Now since the hub and sensor on that side is also quite new...

Ok, will try that although last time i tried to get some live data from the slabs system, my nanocom kept loosing connection so im bot hopeful ill manage. Maybe its really time for a new slabs ecu.

Honestly I dont think its the driver side as i had replaced that not long ago. Now both front ones are less than a few months old but still having the errors come up!

hi all, im getting the 3 amigos. plugged in nanocom, said it was left wheel sensor. fine, changed hub and sensor with a new oem and after a short drive three amigos are back!! same error. any idea? could it be a caliper issue? or maybe the slabs ecu itself? if it is the ecu itself, which is the...

got one, been there for 2yrs now, no issues. 200 is a lot cheaper than the 800 that the other ones used to cost anyway

dont think so but i have seen them popping back up for sale so its no longer a concern for now lol

cupholder spring thing broke, was just wondering how difficult it is to remove and repair/replace?

so basically stuck a known good genuine one and it works perfectly now. no wonder they call them ****part... incidentally my next job is to replace the 6m old britpart bushes