Tie the rope to the rear of the car so when you drive off,the ramps will follow. Saves walking too far carrying them back to the garage

What thread ??

Any update on the ignoring of the thread? Have you resolved the problems

You need 50 posts… and your nearly there Post a few more times in this thread & you will be permitted

That’s probally an original relay. Mine were like that. Unsure what relay size these are. I had a (landrover) green 5pin relay laying around & have been using this. If it’s not the relay causing your problem it’s the ignition switch on the rear of the barrel

You don’t need to do a course. As long as you have a methodical way of taking things apart & can weld you will be good. Have a look through of the threads where people have rebuilt these & you will see what’s involved. Good luck & enjoy.

They rot in the same places as a disco. Hard to find a nice RRC that has not been butchered. Saw 1 the other week pushed out of a bush make £5k no engine or box(was a 2door but still rotten)

They have a long power cable length normally ,my relays are on the upright by the radiator for easy acsess. Main power lead is fed off the starter solinoid,saved me going back to the battery. Switching is done off the old headlight circuit on to the relays Only thing I ever noticed is going to...

Use a set of jump leads to test. Also can use the leads as extra earths,then if all good just put some more on

If it cranks by hand,all is free. Have you used the same starter motor? & is that free ? What type of starter is it?

Can you fix any thing to zip tie /metal strap these under the bonnet.

That would mean you got a later speedo cable for an earlier motor. The later speedo drive ends are very small

No cable in the middle is correct.

Is the clickeing the glow plug relay? Or is yours under the bonnet Nothing else clicks near my fuse box(early glass fuse type)

You would enjoy that… the mounts are all in the same places and floor pans etc same design.

Think mine had the relay as it was a V8 (1985)

Hope this helps Ignition off Brown live 12b Brown/red 0 Black 0 White/red 0 Start up(12v) Brown live Brown/red live Red/white live Black 0 Ignition off.. Jump across brown + white/red Engine will turn over Ignition on.. same as above but engine will run Just confirmed the above,standard...

Few questions.. Have you/could you disturbed the rear of the ignition barrel? Starter relay. Just swap this for a relay close to it to check it works. Think they are all 4 spade relays . I have a relay fitted to mine will check the voltage this afternoon when I’m back home.

Thin cable excites the alternator to make a change. So light should be on with ignition. Once running the charge should turn out the light. Make sure little cable goes on little connector. The 2 large lugs are joined

Don’t worry about asking. We are all here to help. Your write ups are spot on & helpful to the forum.