Ah. Does anyone have the bit count numbers correlating to the factory heights in mm? Or is that on the previous page?

I understand that they're not inches just that multiple "Experts" told me that the numbers don't have any measurements units and they're just a reference for the diagnostic...

Are the measurements in mm?

Are these values of any use...

I've rebuilt my compressor but the bugger will be needing a new one at the rate its going up & down...

Feynerial, does your take an age to drop down to its lowest height too, if at all? If I put the kicker in sometimes it behaves itself for a few seconds and I can adjust the height sometimes. But that doesn't last long before the switch completely lights up and the dash reads an EAS fault.

That's EXACTLY what mine says and does.

Nanocom Evolution by Blackbox apparently.

I'll find out. It's actually my brothers diagnostic tool.

More often than not the up down switch lights operate for a few second without incident and the car will be roughly at the right height then all the lights on the switch come on and an EAS fault is read out on the dashboard (along with an airbag fault which is new)

Ah! Is that a fact. That's interesting. So would the diagnostic still register the sensor out of range if it was a bad connection the height switch? That would be so much simpler...

Ah yes I have a DMM. What an idiot I am for not realising that, haha. Well like I say, DM me if you would like futher details. They £3000-£3500 a piece so they're not cheap mind you.

Thanks Lads, BTW! All your input is fantastic. I hope it's helpful to each other too!

Ooow. Where do you get those and what's it's full name?

Well these aren't mine I have to say. They belong to a friend of mine who builds them for people. I can give him your details if you want one 😉. I build my own too to high standards as per the original but my workshop is in the works lol.

Sadly, I don't have him anymore but new Daleks are in the pipeline...

Did you take any pictures. Where do the wires go. Under the carpet?

Haha my suspension goes up and down and the EAS is beeping away at me all the time on the dash...

Sorry I said CPU instead of ECU. My bad. So I'll just have to follow the cables back until I find the right ones...

Well I'll do that anyway. So where do the height sensor cables come in. I've replaced all the sensors but the diagnostic still says the front left is out of range. I've replaced the CPU and relay with no difference. All I can think is its the physical wires themselves to the actual sensor.