So I am! It was suggested as a similar thread! I thought it was current! My bad!

What condition is your PCV in? Mine was split and caused havoc with running, I’ve got a similar issue with mine at the moment, running rough when warm, same carb, but it’s bogging down on full throttle, appears to be a timing / carb tune issue

Thanks K, when you say adjust the revs you mean the throttle linkage?

Thanks Kermit, its a brand new weber so should be able to! thanks, Ill try adjusting the timing and tinker with the mixture screw,

I built a Quad lock one for mine, it locks to my phone case and charges my phone also - I connect via Bluetooth to my stereo system,

Hello, Ive been having an issue with my Series 3, 2.25 petrol: Upon start up I don't often need the choke, and have to shut it off pretty quickly to prevent poor running if i do use it, Once warm I have to limit throttle input, if I floor it the engine just bogs, I should also note, that it...

Gents, Bought some replacement Tail lights for my SIII SWB, The old lights only had two wires (and earthed through the light fitting) the new ones are plastic and have three wires, Can some one shed some light as to how to wire these? on the fitting I have Red/Black - which I have...

Hello mate, I have not dealt with the aerial hole yet, I’m thinking I may use it for a CB radio Whip, I was going to integrate one into my rig somewhere! Just haven’t worked out where yet!!

thanks Rich, yes they are Exmoor trim canvas cards!

So Ive not been on here for a while, Over the last month or so I’ve have a lot of the mechanicals overhauled, New front Exhaust to stop a leak, New Brakes and hoses due to wear and leaks, had the Hubs rebuilt and the Swivels replaced, New Choke cable, New rear axel Check straps, replaced the...

Thanks for the comments guys

Thank you, that Is high praise indeed

Thanks for the ideas guys, I don't think the checker plate is for this truck maybe I can get something turned to fit and cap it, I might go to the chandlers and see if they have anything!

Interesting thoughts there Thanks! I will let you know what I decide!

Compressor install now complete, I have two quick connector outlets, one on the rear crossmember and one on the passenger side with the receiver/tank Also have a reg / filter for moisture and to keep an eye on the pressure Not sure what to do next! Will have to give it some thought...

good Man! @Timasmith86 and @jackuar_land_rover if anyone is interested!