Bolt plate part number mrc5509. shown in the book as fitting the seat rail to the seat box. Only one supplied bottom of pic.

Hi folks, As the header says ..why only one? Does it fit the petrol tank side? any ideas. Cats

Well I'll have to see when the time comes for fitting. Thanks for the input.

Hi again, I had a rummage through a box of old rusty grubby nuts and bolts etc. And found these, only two but......see attached photo. This was a discontinued project of one of my sons many years ago and this is what came with a pile of bits.

Thanks for the reply, There must have been so many alterations in the past I dont know what held the seat in place.

Hi folks. Does any one know the actual size of these brackets, And where they fit at the front? They are rather expensive for a simple bracket and I like bending metal and drilling holes , so I was going to make some. Thickness/hole size/dimensions etc. Photo attached , the bracket is at the...

It does look rough at those places. I would contact the supplier and voice your dissatisfaction. Send them photos. You could tidy it up yourself but that is not the point. They may offer a discount.

I'm in Newtown Poole, can't smell anything from here.

I'll have to try that, our one is absolutely filthy and multicoloured

I have the same two cables doing nothing on my series 3 4 cyl

Did you ever get this sorted satisfactory?

Hi, I did my first welding on the bulkhead. I was about 70 at the time. If you go down the welding route, make sure you have the bulkhead fitted on the chassis at all four mounting points. Then only remove one at a time to do your work before replacing. If you do it off the chassis then it may...

After searching It looks like I only have one. And that is the right hand one.

Thanks I will take another look when I get into the garage again.

Hi all, Seat box not fitted yet, I was asking because I only found it again and started scratching my head but couldn't find any hair. Next job is lining up the new tub to the bulkhead then locating the oil leak which has strangely appeared. Cheers all.

I am still going through a box of bits and have found this. cheers if you know. Even my son who tookit apart 9 years ago doesn't know.

Thank for the info. Both the wires have come off now ,they were only hanging on by one strand. I hope trial and error will show me.

I have found a picture of the arrangement online, interesting. The fan was already removed when I took over the build. I just cleaned and painted it, there was no resistor there. I had to rebuild the heater matrix box,it was rotton although the radiator was fine. Any idea of the value (ohms) of...

This is what I have, one spade and an earth at the back .

Hi folks, As the header says. I have a 2 speed blower motor with one spade terminal and one earth lead coming out. I did not take it off so I am not 100 pc how it connects back. I connected both wires from the bulkhead to the spade and it works only at one speed. Swapping the wires around...