One thing I've learnt, buy a hub with the wheel flange already mounted. Taken me two days to pull apart the bearing and get into a position to reset the flange into the new bearing. Have about 20mm left to drive it in but think that's all I can be bothered with tonight. Don't have a press so...

Aye, tried it with a cheater bar too to give me about 6' but all I got was bent bars. Could have done with some scaf bar but didn't have any. Bit the bullet - Gone to the garage this morning for them to get it going for me. Ha ha - It would be nice not to need change five hubs. For putting...

School boy error? At the risk of looking stupid I had checked the new one and it felt like a normal thread. Yeah, might be a job for that. I'd be tempted to use a nut splitter but I'd not get one in. Annoyingly had to reassemble everything today to move it across the drive and get a delivery...

Update: Got a test drive done last week, like (bad) magic everything lit up again & definite fault code from the RH front hub. Only had chance to get back on it today. Hub is a heap of rust but got all but the axle nut off. That begger I cannot shift, knocked the stake out then tried my breaker...

Cheers guys. Ha ha - that's good to know then. Aye, true that but in the middle of town so no convenient field or lane for a test run. Sounds like it's worth doing the hub, then fingers crossed.

Aye, well I have the fault codes from the Lynx. But do you just mean the Lynx isn't up to much? Probably a separate topic. Edit: Fault codes attached... Initial ABS faults: Running data: Of those faults none have returned but maybe it's just a because it's not had a test drive. There were a...

Really, never noticed? Might do. However I had all three lights with normal driving before I cleared the code so I'm something was there unless they've gone on and not turned themselves off. I'd guessed at the time it was a wheel-bearing or sensor which I figured the garage could do when they...

Double post

Johnlad - bum, that might be a bit full-on to do on the drive. ;-)

Hi, cheer Brian/MJI, Yeah, I've had it on a Lynx. Only had fault codes listed as historical, cleared them out and the HD & TC lights went out, but ABS is still on. Except now it doesn't show any codes. Aye, I think I've seen that switch mod. Might give that a go, though I read the resistance...

Familiar topic I'm sure... Busy clearing the MOT fail list on a Disco 2, pretty much the only thing left is the Three Amigos but I've had no luck sorting it. (Been through the threads here and elsewhere but not seen anything obviously similar to the problems below). Spec: Disco 2 2004 Td5 Auto...

Been using the information off here for a fair while (thanks guys). Have a late model Discovery 2 Td5, which is gradually collecting all the usual problems. Finally need to start posting.