You may need a rotary coupler? They are cheap and easy to replace? Kevv

eBay!! £22 upwards? Kev

You will need to raise the the car and check to see if there is any play on the Driveshaft to confirm? Give it a hard pull and push. Kev

Sounds like the Driveshaft?? Just changed my left side front this weekend! With the driver side front also to finish? The noise your explaining? Was the same from my FL td4? Only have the noise from the driver side now? Kev

Hi all, Thanks all for the advice, much welcomed. The bolt has been removed! I had to take to a friend's garage for him to weld a remove it! So no recorded details apart from picture of the offending article 🤬 Even asking him to remove it! It took 2 hours!?!?! Lesson learned for the next one...

Are you replacing the sagging material? Or like me, ripping it out, cleaning and then painting it? As for accessories! I just checked all the bits and pieces and replaced with new if needed! If you start adding? You will need to remove headliner again to sort out the possible problem?? Kev

Have you a picture?? Kev

Have you checked Silverlakes?? Kev

I also have that issue? Have checked, thought I had put the spring on incorrect! They were colour coded to Nearside and Offside but were installed correctly! Then checked the shocks! Again installed correctly! It is just noticeable with no kit in the back! 🤔 Kev

Has been explained in previous posts! Whole weekend trying to get the thing out, with out the us off weld! Kev

@frostythor Thanks for that! Will keep that in mind for the driver side as well, if I start having problems👍☺️ And will look at that if the weld doesn't work Kev Ps: is that from Freelander RAVE??

Freelander 1 The driveshaft! Kev

I tried that 😳 I spent 3-4 hours drilling, heating, knocking and asking nicely (and not so nice)🤣 I ran out of HSS drill bits! (3 used)On a Sunday!! Used 2 mapx bottles for heating the bloody thing! Restricted to about 6-8ins swing with the hammer! To hit the bloody thing! (That's with the...

Driveshaft! Kev

That's for practice at a later date! When I get my Arse in gear to start teaching myself from the university of Google and the college of YouTube and watch a friend in the garage? 😀👍👶 Kev

No room🥴 Kev

I will try and remember 😄 Whist trying at the weekend! The last thing on my mind was camera?? (Lots of 🤬😡🤬😡🤬🤬😡😡🤬😱🤬😡😡🤬😡) Kev

@Stanleysteamer the bottom bit is going in the bin mate! Kev

Thank 👍😀 Kev

Not worried about below, as it is being changed! Worn!! Still enough metal on the bolt head for weld! Hoping that when I do! The heat will help shift the rust in the hole🙏😳 Kev