Cheers for the advice it seemed to be the third fuse was burnt out and then it work. Might not be connected but it's working now

Hi everyone I am have a few problems with my lights wiring but at the minute I'm struggling with fog lights. It's a 200tdi wiring bulkhead loom 19j chassis loom. The is 10v going across the switch but at the other end of the bulkhead there is only 0.5v. I check the bulb and unit it's working...

Final started the engine after a year or two of being rebuilt. However after it was turned off oil sprayed out of the top oil joint into the oil filter (in picture). I tightened it as tight as I could but it did it again. Any ideas? Could it still need tightened more? Help!

Hi I need help. I have a 1987 ninety 19j with 200tdi bulkhead wiring loom: 1st. When I connect the battery a relay turns on and the dash lights come on. Is that right? 2nd. What order is the ignition barrel suppose to be wired. There's a brown, white, white/red and white/orange wires. What...

i have just put a 200tdi wiring loom into my 1987 ninety so I had to use a 200tdi ignition, Lucas ssb300. I am not sure what wire I need to connect to each terminal. There's 4 wires brown, white+orange, white+red and white.

They don't have a online shop. You have to phone them or go to the shop but they are very helpful.

Thanks good to learn more about land rovers all the time

Could anyone please explain what this axle is and how it's different from a normal one :)

I'm in NI too and I get most of my stuff from BLRC.

Give it a blanky :D

I'm not sure

I'm not sure.

http://m.ebay.co.uk/itm/271637912171?_mwBanner=1

Are these seats being sold by anyone on here.

Thanks for the help

I am looking for defender brake pipes and can't find them anywhere. The only thing I found out was there is different types of pipes. Q1. what type of pipe should I use kunifer or copper Q2. Where do I get them?

Thanks

Just got a full set of polybush but when I put them in I was trying to put the rear radius arm to the axle and it won't fit because the polybush makes it too wide. I took out the metal sleeve and was able to put the rubber bits in tighter and it fitted but I then put the sleeve back in and...

Thanks for the advice

Is it easy to transfer 1987 ninety wiring loom to new galv. chassis? Any tips?