1. W

    Whats this connector for

    As per title can someone identify this connector. Thanks in advance.
  2. W

    Locks and keys

    On my 2002 110 hard top the front doors are push button with long key locks like the ign key. The rear door us lift up handle and shirt key/lock and tge fuel cap a different key again with a short key lock. My question is can they be changed or upgraded to a one key system or is it just what it...
  3. W

    Seatbelt fitment

    Afternoon all hope you can advise on this 110 Defender 2002 hard top with basic spec. I need to replace the front seatbelts but find that when I search for td5 ones the price increases substantially. Why? There's no dash warning lights or pretensioners etc so I'm wondering what the difference...
  4. W

    What electronics compared to a D2

    Good morning everyone. I currently run a disco2 but always hankered for a defender 110. I have nanocom so all good on that front and a very strong electrical and mechanical background. The question is does the td5 defender 02 plate only have ecu control on the engine. What about a bcu or abs...
  5. W

    D2 half chassis

    Hi guys im about to embark tomorrow on a 1/2chassis replacement in my d2. I have a couple of concerns as follows. I intend to support rear of vehicle by placing a support across the chassis from side to side just in front of the rear trailing arms. I concerned the body structure may droop after...
  6. W

    Slabs timer??

    Does anyone know how long the slabs timer runs when the ign is turned off?? To clarify I had a flat battery. I thought Id do a drain check and found that after turnining everything off there was a current draw of around 1/2 an amp. I've traced this to fuse 11 (30amp) in the engine bay. Remove...
  7. W

    Roll bar clamps

    A quickie question before I but but are the front and rear anti roll bar clamps for bushes the same between the ace and non ace bars ? With the bushes being different. Thanks in advance.
  8. W

    Heights confusion.

    Ok so following on from sill and chassis welding I have these possible? Issues. I had to patch behind the left hand height sensor and fabricate and fit a new bracket for the sensor. So the issues were an uneven height at rear due to sensor readings changing. I set nanocom up and recalibrate...
  9. W

    Spring confusion

    Good afternoon everyone. Well an mot fail today but not to bad. All flex brake pipes need replaced and front spring on drivers side. But what springs? I want to keep std but what was std on an 03 disco2 with 7 seats ace and air. GS model. The colour codes have all but gone on mines. Pass side...
  10. W

    110 advice

    As above. I am looking at an F plate 110 CSW. It looks very fresh chassis wise and overall looks very well. However there are issues I would like advice on. The conversion to a discovery 300tdi and r 380 gearbox was done by the owner before this one. The new owner says the temp gauge reads...